63900-4770 Molex

Fine Adjust Applicator for 2.00mm (.079 ) Pitch Micro SPOX Crimp Terminal Crimp Terminals FineAdjust Applicator Specification Sheet Part No. 63900-4700 FEATURES Quick punch removal with the push of a button for fast and easy tooling change Applicator designed to industry standard mounting and shut height 135.80mm (5.346 ) Quick set-up time plus the crimp height, track and feed adjustments can be set without removing the applicator from the press Fine adjustment allows users to achieve target with little effort by adjusting in increments of .015mm (.0006 ) for conductor crimp height and .063mm (.0025 ) for insulation height Independent adjustment rings allow users to quickly adjust the conductor or insulation crimp height without affecting each other Directly adapts to most automatic wire processing machines SCOPE Products: 2.00mm (.079 ) Pitch Micro SPOX Crimp Terminal, 22-30 AWG. Wire Size Insulation Diameter Strip Length Terminal Series No Terminal Order No. AWG mm mm In. mm In. 5230 08-70-0072 22-30 0.35-0.05 0.80-1.50 .031-.059 2.60-3.10 .102-.122 DEFINITION OF TERMS BEND UP BELL MOUTH BRUSH SEAM INSULATION CRIMP ROLLING TWISTING STRIP BEND LENGTH DOWN CONDUCTOR CUT-OFF TAB COND.CRIMP CRIMP HEIGHT The above terminal drawing is a generic terminal representation. It is not an image of a terminal listed in the scope. Doc No: ATS-639004700 Release Date: 08-17-07 UNCONTROLLED COPY Page 1 of 5 Revision: A Revision Date: 08-17-07 Fine Adjust Applicator for 2.00mm (.079 ) Pitch Micro SPOX Crimp Terminal Crimp Terminals CRIMP SPECIFICATION Bell mouth Cut-off Tab Maximum Conductor Brush Terminal Series No. mm In. mm In. mm In. 5230 0.20-0.50 .008-.020 0.30 .012 0.00-1.00 .000-.039 Bend up Bend down Twist Roll Punch Width mm (Ref) Seam Terminal Series No. Conductor Insulation Degree Degree Seam shall not be open and mm In mm In no wire allowed out of the 5230 8 0 3 8 1.20 .047 1.40 .055 crimping area After crimping, the conductor profile should measure the following. Wire Size Conductor Crimp Height Pull Force Minimum Terminal Series No. 2 AWG mm mm In. N Lb. 22 0.35 0.84-0.89 .033-.035 39.1 8.8 24 0.20 0.76-0.81 .030-.032 29.3 6.6 5230 26 0.12 0.69-0.74 .027-.029 19.6 4.4 28 0.08 0.66-0.71 .026-.028 9.8 2.2 30 0.05 0.63-0.68 .025-.027 4.9 1.1 Pull Force should be measured with no influence from the insulation crimp. The above specifications are guidelines to an optimum crimp. Doc No: ATS-639004700 Release Date: 08-17-07 UNCONTROLLED COPY Page 2 of 5 Revision: A Revision Date: 08-17-07