63851-1070 Molex

63851-1000 T2 Terminator T2 Terminator Tooling Specification Sheet Part No. 63851-1000 FEATURES It is ideally suited for mid-volume bench operations This terminator can be installed in the TM42 and the TM40 press or Base Unit adapter for 3BF press Quick punch removal with the push of a button for fast and easy tooling change Track adjustment capabilities in the T2 Terminators for improved control of the bell mouth size and cutoff tab length T2 Terminator has standardized tooling with the Molex FineAdjust Applicator which will reduce your inventory requirements SCOPE Wire Size Insulation Diameter Strip Length Terminal Series No. AWG mm mm In. mm In. 50535-9001 16-18 0.80-1.30 2.00-2.45 .079-.096 3.70-4.20 .146-.165 DEFINITION OF TERMS BEND UP ROLLING SEAM BELL CONDUCTOR BRUSH MOUTH CRIMP INSULATION CRIMP TWISTING STRIP LENGTH BEND DOWN CUT-OFF CRIMP HEIGHT TAB The above terminal drawing is a generic terminal representation. It is not an image of a terminal listed in the scope. Doc No. 63851-1000 Release Date: 04-28-00 UNCONTROLLED COPY Page 1 of 6 Revision: B Revision Date: 02-17-04 63851-1000 T2 Terminator CRIMP SPECIFICATION Bell mouth Cut-off Tab Max. Conductor Brush Terminal Series No. mm In. mm In. mm In. 50535-9001 0.20-0.70 .008-.028 0.20 .008 0.00-1.00 .000-.039 Bend up Bend down Twist Roll Punch Width (Ref) Seam Terminal Series No. Conductor Insulation Seam shall not be open Degree Degree mm In mm In and no wire allowed out of the crimping area 50535-9001 3 2 3 5 2.20 .086 2.80 .110 After crimping, the conductor profile should measure the following. Wire Size Crimp Height Pull Force Min. Terminal Series No. 2 AWG mm mm In. N Lb. 50535-9001 16 1.30 1.51-1.61 .059-.063 127.4 28.7 50535-9001 18 0.80 1.33-1.43 .052-.056 88.2 19.8 Pull Force should be measured with no influence from the insulation crimp. The above specifications are guidelines to an optimum crimp. Doc No. 63851-1000 Release Date: 04-28-00 UNCONTROLLED COPY Page 2 of 6 Revision: B Revision Date: 02-17-04