NXP Semiconductors K63P144M120SF5 Data Sheet: Technical Data Rev. 7, 11/2016 Kinetis K63F Sub-Family Data MK63FN1M0VLQ12 MK63FN1M0VMD12 Sheet 120 MHz ARM Cortex-M4-based Microcontroller with FPU The K63 product family members are optimized for cost-sensitive applications requiring low-power, USB/Ethernet connectivity, up to 256 KB of embedded SRAM and the need for extensive tamper protection, such as Electronic Point of Sales. These devices share the comprehensive enablement and scalability of the Kinetis family. This product offers: 144 LQFP 144 MAPBGA 20 x 20 x 1.6 mm Pitch 13 x 13 x 1.46 mm Run power consumption down to 250 A/MHz. Static 0.5 mm Pitch 1 mm power consumption down to 5.8 A with full state retention and 5 s wakeup. Lowest Static mode down to 339 nA DryIce Tamper Detection with active/passive pin, temperature, clock, supply voltage monitoring USB LS/FS OTG 2.0 with embedded 3.3 V, 120 mA LDO Vreg, with USB device crystal-less operation 10/100 Mbit/s Ethernet MAC with MII and RMII interfaces Performance Communication interfaces Up to 120 MHz ARM Cortex-M4 core with DSP Ethernet controller with MII and RMII interface instructions and floating point unit USB full-/low-speed On-the-Go controller Controller Area Network (CAN) module Memories and memory interfaces Three SPI modules Up to 1 MB program flash memory and 256 KB RAM Three I2C modules. Support for up to 1 Mbit/s FlexBus external bus interface Six UART modules Secure Digital Host Controller (SDHC) System peripherals I2S module Multiple low-power modes, low-leakage wake-up unit Memory protection unit with multi-master protection Timers 16-channel DMA controller Two 8-channel Flex-Timers (PWM/Motor control) External watchdog monitor and software watchdog Two 2-channel FlexTimers (PWM/Quad decoder) IEEE 1588 timers Security and integrity modules 32-bit PITs and 16-bit low-power timers Hardware CRC module Real-time clock Tamper detect and secure storage Programmable delay block Hardware random-number generator Hardware encryption supporting DES, 3DES, AES, Clocks MD5, SHA-1, and SHA-256 algorithms 3 to 32 MHz and 32 kHz crystal oscillator 128-bit unique identification (ID) number per chip PLL, FLL, and multiple internal oscillators 48 MHz Internal Reference Clock (IRC48M) Analog modules Two 16-bit SAR ADCs Operating Characteristics Two 12-bit DACs Voltage range: 1.71 to 3.6 V Three analog comparators (CMP) Flash write voltage range: 1.71 to 3.6 V Voltage reference Temperature range (ambient): 40 to 105C NXP reserves the right to change the production detail specifications as may be required to permit improvements in the design of its products.Ordering Information 1 Part Number Memory Maximum number of I O s Flash SRAM (KB) MK63FN1M0VLQ12 1 MB 256 100 MK63FN1M0VMD12 1 MB 256 95 1. To confirm current availability of ordererable part numbers, go to