Document Number MKE02P64M40SF0 NXP Semiconductors Rev. 6, 12/2019 Data Sheet: Technical Data MKE02P64M40SF0 KE02 Sub-Family Data Sheet Supports the following: MKE02Z16VLC4(R), MKE02Z32VLC4(R), MKE02Z64VLC4(R), MKE02Z16VLD4(R), MKE02Z32VLD4(R), MKE02Z64VLD4(R), MKE02Z32VLH4(R), MKE02Z64VLH4(R), MKE02Z32VQH4(R), MKE02Z64VQH4(R), MKE02Z16VFM4(R), MKE02Z32VFM4(R), and MKE02Z64VFM4(R) Key features System peripherals Power management module (PMC) with three power Operating characteristics modes: Run, Wait, Stop Voltage range: 2.7 to 5.5 V Low-voltage detection (LVD) with reset or interrupt, Flash write voltage range: 2.7 to 5.5 V selectable trip points Temperature range (ambient): -40 to 105C Watchdog with independent clock source (WDOG) Performance Programmable cyclic redundancy check module Up to 40 MHz Arm Cortex-M0+ core and up to 20 (CRC) MHz bus clock Serial wire debug interface (SWD) Single cycle 32-bit x 32-bit multiplier Bit manipulation engine (BME) Single cycle I/O access port Security and integrity modules Memories and memory interfaces 64-bit unique identification (ID) number per chip Up to 64 KB flash Human-machine interface Up to 256 B EEPROM Up to 57 general-purpose input/output (GPIO) Up to 4 KB RAM Two up to 8-bit keyboard interrupt modules (KBI) Clocks External interrupt (IRQ) Oscillator (OSC) - supports 32.768 kHz crystal or 4 Analog modules MHz to 20 MHz crystal or ceramic resonator choice One up to 16-channel 12-bit SAR ADC, operation in of low power or high gain oscillators Stop mode, optional hardware trigger (ADC) Internal clock source (ICS) - internal FLL with Two analog comparators containing a 6-bit DAC internal or external reference, 31.25 kHz pre- and programmable reference input (ACMP) trimmed internal reference for 32 MHz system clock (able to be trimmed for up to 40 MHz system clock) Internal 1 kHz low-power oscillator (LPO) NXP reserves the right to change the production detail specifications as may be required to permit improvements in the design of its products. Timers One 6-channel FlexTimer/PWM (FTM) Two 2-channel FlexTimer/PWM (FTM) One 2-channel periodic interrupt timer (PIT) One real-time clock (RTC) Communication interfaces Two SPI modules (SPI) Up to three UART modules (UART) One I2C module (I2C) Package options 64-pin QFP/LQFP 44-pin LQFP 32-pin LQFP 32-pin QFN KE02 Sub-Family Data Sheet, Rev. 6, 12/2019 2 NXP Semiconductors