Document Number S9KEA64P64M20SF0 NXP Semiconductors Rev. 6, 10/2019 Data Sheet: Technical Data S9KEA64P64M20SF0 KEA64 Sub-Family Data Sheet Supports the following: S9KEAZN16AMLC(R), S9KEAZN32AMLC(R), S9KEAZN64AMLC(R), S9KEAZN16AMLH(R), S9KEAZN32AMLH(R), and S9KEAZN64AMLH(R) Key features System peripherals Power management module (PMC) with three power Operating characteristics modes: Run, Wait, Stop Voltage range: 2.7 to 5.5 V Low-voltage detection (LVD) with reset or interrupt, Flash write voltage range: 2.7 to 5.5 V selectable trip points Temperature range (ambient): -40 to 125C Watchdog with independent clock source (WDOG) Performance Programmable cyclic redundancy check module Up to 40 MHz Arm Cortex-M0+ core and up to 20 (CRC) MHz bus clock Serial wire debug interface (SWD) Single cycle 32-bit x 32-bit multiplier Bit manipulation engine (BME) Single cycle I/O access port Security and integrity modules Memories and memory interfaces 64-bit unique identification (ID) number per chip Up to 64 KB flash Human-machine interface Up to 256 B EEPROM Up to 57 general-purpose input/output (GPIO) Up to 4 KB RAM Up to 22 general-purpose input/output (GPIO) Clocks Up to 14 general-purpose input/output (GPIO) Oscillator (OSC) - supports 32.768 kHz crystal or 4 Two up to 8-bit keyboard interrupt modules (KBI) MHz to 20 MHz crystal or ceramic resonator choice External interrupt (IRQ) of low power or high gain oscillators Analog modules Internal clock source (ICS) - internal FLL with One up to 16-channel 12-bit SAR ADC, operation in internal or external reference, 31.25 kHz pre- Stop mode, optional hardware trigger (ADC) trimmed internal reference for 40 MHz system and Two analog comparators containing a 6-bit DAC core clock. and programmable reference input (ACMP) Internal 1 kHz low-power oscillator (LPO) Timers One 6-channel FlexTimer/PWM (FTM) Two 2-channel FlexTimer/PWM (FTM) One 2-channel periodic interrupt timer (PIT) One real-time clock (RTC) Communication interfaces Two SPI modules (SPI) Up to three UART modules (UART) One I2C module (I2C) NXP reserves the right to change the production detail specifications as may be required to permit improvements in the design of its products. Package options 64-pin LQFP 32-pin LQFP KEA64 Sub-Family Data Sheet, Rev. 6, 10/2019 2 NXP Semiconductors