NX-PC0010 Omron

NX-series System Unit NX-PD/PF/PC/TBX CSM NX-PD PF PC TBX DS E 5 1 Power Supply Unit, Power Connection Unit, and FG Terminal Expansion Unit for NX-series Features Units to feed in additional Unit power and I/O power to an NX-series remote I/O terminal. Screwless clamp terminal block significantly reduces wiring work. Space-saving 12 mm wide units. The NX Unit Power Supply Unit allows expansion of the I/O configuration beyond the maximum power supply capacity of the EtherCAT Coupler The I/O Power Supply Unit is used when the total allowed I/O current per feed terminal is exceeded, or to split I/O power into groups. The I/O Power Connection Unit can be used as an additional power supply terminal for connected sensors and actuators. The FG Terminal Expansion Unit can be used as ground terminal for wire shields. The screwless terminal block is detachable for easy commissioning and maintenance. Sysmac is a trademark or registered trademark of OMRON Corporation in Japan and other countries for OMRON factory automation products. TM EtherCAT is a registered trademark of Beckhoff Automation GmbH for their patented technology. EtherNet/IP is the trademarks of ODVA. Other company names and product names in this document are the trademarks or registered trademarks of their respective companies. 1NX-PD/PF/PC/TBX System Configuration System Configuration in the Case of a CPU Unit The following figure shows a system configuration when a group of NX Units is connected to an NX-series CPU Unit. Sysmac Studio CPU Rack Support Software NX-series CPU Unit NX1P2- Connection to built-in TM EtherNet/IP port Built-in EtherCAT port End Cover NX Units EtherCAT Slave Terminal EtherCAT NX Units EtherCAT Coupler Unit Note: For whether an NX Unit can be connected to the CPU Unit, refer to the version information. System Configuration of Slave Terminals The following figure shows an example of the system configuration when an EtherCAT Coupler Unit is used as a Communications Coupler Unit. Sysmac Studio EtherCAT master *2 Support Software NJ/NX-series CPU Unit, NY-series Industrial PC, or master from another manufacturer Connection to peripheral USB port or built-in EtherNet/IP port on CPU Unit or Industrial PC *1 .xml ESI files Built-in EtherCAT port EtherCAT Slave Terminal Sysmac Studio Support Software Communications cable NX Series Ethernet cables EtherCAT Coupler Unit NX-ECC Peripheral USB port. Connection to peripheral USB port on EtherCAT Coupler Unit .xml ESI files End Cover NX Units *1. The connection method for the Sysmac Studio depends on the model of the CPU Unit or Industrial PC. *2. An EtherCAT Slave Terminal cannot be connected to any of the OMRON CJ1W-NC 81/ 82 Position Control Units even though they can operate as EtherCAT masters. Note: For whether an NX Unit can be connected to the Communications Coupler Unit, refer to the version information. 2