Ordering number : ENA2341 LV25810PEB Bi-CMOS LSI LV25810PEB Absolute Maximum Ratings at Ta=25C, VSS=0V Parameter Symbol Pin name Conditions Value unit Supply voltage Vcc1 max VCC (5V) For FE analog 0.3 to 5.8 V VDD33, PLLVDD, XVDD, Supply voltage Vcc2 max For FE logic, BE ADC, and DAC 0.3 to 3.9 V AVDD33, DACVDD (3.3V) BE logic power supply VDD15 w/ internal regulator and external Supply voltage Vcc3 max 0.3 to 1.8 V (1.5V) FET, external power supply is unnecessary. VIN1max *1 VSS 0.3 to VDD+0.3 V Input voltage VIN2max *2 VSS 0.3 to 5.5 V Operating Topr C 40 to +85 temperature Storage Tstg C 50 to +125 temperature *1) Please refer the Pin Overview list of Page5/Page6 for the details of each VDD name and the supply voltage to them. *2) TEST, RSTB, BL SEL, BL LRCK, BL BCLK, BL DATA, I2C SCL, I2C SDA, TESTI1, TESTI2 Only when the power supplies are On, you can apply voltage to input pin up to 5.5V. When the power is OFF, you can only apply voltage up to 3.6V. Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality should not be assumed, damage may occur and reliability may be affected. Allowable operating range at Ta=40 to +85C, VSS=0V Parameter Symbol Pin name Conditions Min. Typ. Max. unit VCC OSC VCC IF Supply voltage Vcc1 4.75 5.0 5.25 V VCC AM VCC FM VDD33, Supply voltage Vcc21 3.15 3.3 3.45 V PLLVDD, XVDD AVDD33, Supply voltage Vcc22 3.15 3.3 3.45 V DACVDD Supply voltage Vcc3 VDD15 1.42 1.5 1.58 V Input H level voltage VIH *4 2.0 V Input L level voltage VIL *4 0.8 V 78mm106mm1.7mm PWB Allowable power (Glass epoxy, Double-sided) dissipation Pdmax Ta=85C, 1250 mW *3 Exposed-Die-Pad is soldered to GND. LW 146k 281k AM reception MW 520k 1710k Hz frequency SW 2.28M 26.1M FM reception E-EU, EU, US, Japan 65 108 MHz frequency WB reception WB 162.4 162.55MHz frequency Xtal oscillator XIN, XOUT *5 62.4 MHz frequency *3) Required more than 90% of Exposed Die-Pad area to be soldered to GND. *4) TEST, RSTB, MODE, BL SEL, BL LRCK, BL BCLK, BL DATA, SP SSB, SP CLK, SP DI, SP DO *5) Xtal CI value 40 (Xtal oscillator) In Xtal oscillation circuit, circuit constant fluctuates depends on Xtal oscillator and a pattern of a board. Therefore, it is recommended that a manufactures of the Xtal oscillator performs an evaluation. No.A2341-2/28