Ordering number : ENA2017B LV5694P Bi-CMOS IC LV5694P Specifications Absolute Maximum Ratings at Ta = 25C Parameter Symbol Conditions Ratings Unit Power supply voltage V max 36 V CC Power dissipation Pd max IC unit Ta 25C 1.5W At using Al heat sink 5.6 W At infinity heat sink 32.5 W Peak voltage V peak Regarding Bias wave, refer to below the pulse. 50 V CC Junction temperature Tj max 150 C Operating temperature Topr -40 to +85 C Storage temperature Tstg -55 to +150 C Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality should not be assumed, damage may occur and reliability may be affected. Recommended Operating Conditions at Ta = 25C Parameter Conditions Ratings Unit Power supply voltage rating 1 V output, SWD output 7 to 16 V DD Power supply voltage rating 2 ILM output 10.8 to 16 V Power supply voltage rating 3 Audio output, CD output 10 to 16 V Power supply voltage rating 4 ANT output, AMP output 7.5 to 16 V * V 1 should be as follows: V 1>V -0.7V CC CC CC Functional operation above the stresses listed in the Recommended Operating Ranges is not implied. Extended exposure to stresses beyond the Recommended Operating Ranges limits may affect device reliability. Electrical Characteristics at Ta = 25C, V = V 1=14.4V (*2) CC CC Ratings Parameter Symbol Conditions Unit min typ max V 1 input voltage V1 V -0.7V 16 V CC CC CC Current drain I V no load, CTRL1/2/3 = L/L/L 50 100 A CC DD CTRL1/2/3 Input Low input voltage V1 - - 0.3 V IL Middle1 input voltage V1 0.9 1.18 1.45 V IM Middle2 input voltage V2 1.85 2.10 2.4 V IM High input voltage V1 2.95 3.29 5.5 V IH Input impedance R1 Input voltage 3.3V 280 400 520 k IH IKCD/IKV Input DD Low input voltage V2 - - 0.7 V IL High input voltage V2 IKCD V -0.7V - - V IH CC IKV V 1-0.7V DD CC V output (5V/3.3V) DD Output voltage V11 I 1 = 200mA, IKV =V1 4.755.0 5.25V O O DD CC V12 I 1 = 200mA, IKV=GND 3.163.3 3.45V O O DD Output current I1 V 11 4.70V, V 12 3.10V 300 mA O O O Line regulation V 1 7.5V < V 1 < 16V, I 1 = 200mA 30 70 mV OLN CC O Load regulation V 1 1mA < I 1 < 200mA 70 150 mV OLD O Dropout voltage 1 V 1 I 1 = 200mA (V output 5V) 0.8 1.6 V DROP O DD Dropout voltage 2 V 1 I 1 = 100mA (V output 5V) 0.4 0.8 V DROP O DD Ripple rejection R 1 f = 120Hz, I 1 = 200mA 30 40 dB REJ O Short circuit current I1 V 11, V 12 = 0 50 150 340 mA S O O Continued on next page. No.A2017-2/14