Ordering number : ENA1135A LV8086T Bi-CMOS LSI Forward/Reverse Motor Driver LV8086T Allowable Operating Ratings at Ta = 25C, SGND = PGND = 0V Parameter Symbol Conditions Ratings Unit Supply voltage (VM Pin) VM 2.0 to 7.0 V Supply voltage (V Pin) V 2.7 to 5.5 V CC CC Input signal voltage V 0 to V V IN CC Input signal frequenc f max 100 kHz Capacitor for charge pump C1, C2, C3 0.001 to 0.1 F Electrical Characteristics at Ta = 25C, V = VM1 = VM2 = 5.0V, SGND = PGND = 0V, unless especially specified. CC Ratings Parameter Symbol Conditions Unit min typ max Supply current for load at standby IMO EN = 0V 1.0 A Supply current for control at ICO EN = 0V, IN1 = IN2 = IN3 = IN4 = 0V 1.0 A standby Current drain during operation IC1 EN = 5V, VG at no load 0.7 1.2 mA H-level input voltage V 2.7V V 5.5V 0.6V V V IH CC CC CC L-level input voltage V 2.7V V 5.5V 0 0.2V V IL CC CC H-level input current I 1.0 A IH (IN1, IN2, IN3, IN4) L-level input current I -1.0 A IL (IN1, IN2, IN3, IN4) Pull-down resistance (EN1, 2) RUP 100 200 400 k Ta = 25C, V = VM = 5.0V, SGND = PGND = 0V CC Ratings Parameter Symbol Conditions Unit min typ max Output ON resistance RON Sum of ON resistances at top and bottom 0.75 1.2 Charge pump voltage VG 8.5 10.5 V Low-voltage detection operation VCS 2.15 2.30 2.45 V voltage Thermal shutdown operation Tth 180 C temperature Charge pump capacity VGLOAD 8 9 V (IG = 500A) IG current dissipation (Fin = 20kHz) IG 350 A Charge pump start time TVG CVG = 0.1F 1.0ms Output block Turn on time TPLH 0.2 0.4 s Turn off time TPHL 0.2 0.4 s Remarks 1. It shows current dissipation of VM1,2 pin in output OFF state. 2. It shows current dissipation of V pin in stand-by state. CC (The standard current depends on EN pin pull-down resistance.) 3. It shows current dissipation of V pin in state of EN = 5V (stand-by), including current dissipation of VG pin. CC 4. For IN1, IN2, IN3 and IN4 pins, no pull-down and pull-up resistance is needed. (High impedance pin) 5. It shows sum of upper and lower saturation voltages of OUT pin. 6. It controls charge-pump oscillation and makes specified voltage. 7. When low voltage is detected, the lower output is turned OFF. 8. When thermal protection circuit is activated, the lower output is turned OFF. When the heat temperature is fallen, it is turned ON again. 9. IG (VG pin load current) = 500A 10. It shows VG pin current dissipation in state of PWM input for IN pin. 11. It specifies start-up time from 10% to 90% when VG is in non-load state (when setting the capacitor between VG and GND to 0.1F and V is 5V). CC 12. It specifies 10% to 90% for start-up and 90% to 10% for shut-down. No. A1135-2/6