LV8136VGEVB ON Semiconductor

Ordering number : ENA2005 LV8136V Bi-CMOS IC For Brushless Motor Drive LV8136V Specifications Absolute Maximum Ratings at Ta = 25C Parameter Symbol Conditions Ratings Unit Supply voltage V max V pin 18 V CC CC Output current I max 15 mA O Allowable power dissipation Pd max1 Independent IC 0.45 W Pd max2 Mounted on a specified circuit board.* 1.05 W CTL pin applied voltage V max 18 V CTL FG1,FG3 pin applied voltage V 1 max 18 V FG V 3 max FG Junction temperature Tj max 150 C Operating temperature Topr -40 to +105 C Storage temperature Tstg -55 to +150 C * Specified circuit board : 114.3mm 76.1mm 1.6mm, glass epoxy Note 1) Absolute maximum ratings represent the values that cannot be exceeded for any length of time. Note 2) Even when the device is used within the range of absolute maximum ratings, as a result of continuous usage under high temperature, high current, high voltage, or drastic temperature change, the reliability of the IC may be degraded. Please contact us for further details. Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress ratings only. Functional operation above the Recommended Operating Conditions is not implied. Extended exposure to stresses above the Recommended Operating Conditions may affect device reliability. Allowable Operating range at Ta = 25C Parameter Symbol Conditions Ratings Unit Supply voltage range V 9.5 to 16.5V CC 5V constant voltage output current I 10 mA REG HB pin output current I 30 mA HB FG1,FG3 pin output current I 1, I3 10 mA FG FG Electrical Characteristics at Ta = 25C, V = 15V CC Ratings Parameter Symbol Conditions Unit min typ max Supply current 1 I1 5.0 8.0mA CC Supply current 2 I 2 At stop CTL 1.0V typ 0 20 A CC Output Block High level output voltage V I = -10mA VREG-0.35 VREG-0.15 V HO O Low level output voltage V I = 10mA 0.15 0.3 V LO O Lower output ON resistance RL I = 10mA 15 30 ON O Upper output ON resistance RH I = -10mA 15 35 ON O Output leakage current Ileak 10 A O Minimum output pulse width Tmin 2.0 4.0 s Output minimum dead time Tdt 2.0 4.0 s 5V Constant Voltage Output Output voltage VREG I = -5mA 4.7 5.0 5.3 V O Voltage fluctuation V (REG1) V = 9.5 to 16.5V, I = -5mA 100 mV CC O Load fluctuation V (REG2) I = -5 to -10mA 100 mV O Hall Amplifier Input bias current IB (HA) -2 0 A Common-mode input voltage range 1 VICM1 When a Hall element is used 0.3 VREG-1.7 V Common-mode input voltage range 2 VICM2 Single-sided input bias mode 0 VREG V (when a Hall IC is used) Hall input sensitivity VHIN Sine wave, 80 mVp-p Hall element offset = 0V Hysteresis width V (HA) 9 20 40 mV IN Input voltage Low High VSLH 5 11 19 mV Input voltage High Low VSHL -19 -11 -5 mV Continued on next page. No.A2005-2/19