STK433-060N-E ON Semiconductor

OrdeOrdering numbering numberr : ENA2106A : ENA2106A STK433-060N-E Thick-Film Hybrid IC STK433-060N-E Operating Characteristics at Tc = 25C, R = 6 (Non-inductive Load), Rg = 600, VG = 30dB L Conditions *2 Ratings Parameter Symbol Unit V f P THD CC O min typ max V Hz W % Output power *1 P 1 27 20 to 20k 0.4 33 35 O P 2 27 1k 10 50 W O P 3 22 1k 1 R =4 35 O L Total harmonic distortion *1 THD 1 27 20 to 20k 0.4 5.0 VG=30dB % THD 2 27 1k 0.02 Frequency characteristics *1 f , f 27 1.0 +0 -3dB 20 to 50k Hz L H Input impedance ri 27 1k 1.0 55 k Output noise voltage *3 V 33 Rg=2.2k 1.0mVrms NO Quiescent current I 33 No load 15 30 70 mA CCO Quiescent current at stand-by I 33 VST=0V 1.0 mA CST Output neutral voltage V 33 -70 0 +70mV N 13 Stand-by ON threshold *5 VST ON 27 Stand-by 0 0.6 V 13 Stand-by OFF threshold *5 VST OFF 27 Operation 2.5 3.0 5.5 V Note *1. 1channel operation. *2. All tests are measured using a constant-voltage supply unless otherwise specified *3. The output noise voltage is peak value of an average-reading meter with a rms value scale (VTVM). A regulated AC supply (50Hz) should be used to eliminate the effects of AC primary line flicker noise *4. Allowable time for load short-circuit and output noise voltage are measured using the specified transformer power supply. *5. The impression voltage of 13 (Stand-By) pin must not exceed the maximum rating. Power amplifier operate by impressing voltage +2.5 to +5.5V to 13 (Stand-By) pin. * Please connect - PreV pin ( 1 pin) with the stable minimum voltage. CC and connect so that current does not flow in by reverse bias. * In case of heat sink design, we request customer to design in the condition to have assumed market. * The case of this Hybrid-IC is using thermosetting silicon adhesive (TSE322SX). * Weight of HIC : (typ) 12.0g Outer carton dimensions (WLH) : 452mm325mm192mm Specified transformer power supply (Equivalent to MG-200) DBA40C 10000F +V CC + 500 + 500 -V CC 10000F No.A2106-2/11