PAN1740A Bluetooth Low Energy Module Product Specification Rev. 0.1 Wireless Modules PAN1740A Bluetooth Module Overview Features The PAN1740A is an optimized version of the Pre-programmed Bluetooth/MAC address PAN1740, offering a reduced boot time and Includes 16MHz and 32 768kHz crystal supporting up to eight connections. It has a fully calibrated up to 1 ppm integrated radio transceiver and baseband Single mode Bluetooth 5.0 System-on-Chip processor for Bluetooth 5.0 Low Energy (LE). It Programmable ARM Cortex -M0 CPU can be used as a stand-alone application processor Autonomous Bluetooth LE stand-alone operation or as a data pump in hosted systems. The device is Bluetooth 5.0 (LE) embedded GATT profile (LE optimized for remote control units (RCU) requiring single mode) support for voice commands and motion/gesture recognition. Its integrated Audio Unit (AU) offers Dimensions: 9mm x 9.5mm x 1.8mm (SMD package with antenna) easy interface for MEMS microphones over PDM, 2 external codecs over PCM/I S, and a Sample Rate Less than a few A in low power modes Converter unit. The Bluetooth LE firmware includes Integrated shielding to resist EMI the L2CAP service layer protocols, Security No external components needed Manager (SM), Attribute Protocol (ATT), the Generic Attribute Profile (GATT), and the Generic Access Profile (GAP). All profiles published by the Characteristics Bluetooth SIG as well as custom profiles are supported. The transceiver interfaces directly to the Peak power consumption: 4.9mA (Rx and Tx) antenna and is fully compliant with the Link budget: 93 dBm (Rx sensitivity: -93 dBm, Bluetooth 5.0 standard. The PAN1740A has Tx sensitivity 0dBm) dedicated hardware for the Link Layer Operating temperature range -40C to +85C implementation of Bluetooth LE and interface controllers for enhanced connectivity capabilities. Block Diagram Product Specification Rev. 0.1 Page 2