857215 Qorvo

857215 1090 MHz SAW Filter General Description 857215 is a general purpose RF filter designed in a 3x3mm hermetic package SMP-12 3.00 X 3.00 X 1.22 mm Product Features Usable bandwidth 10 MHz High attenuation Low Loss Excellent power handling Single-ended operation No matching required for operation at 50 Functional Block Diagram Small Size: 3.00 x 3.00 x 1.22 mm Ceramic Surface Mount Package (SMP) Hermetically sealed 6 1 Gnd Gnd RoHS compliant, Pb-free P b Input Output 2 5 Applications General purpose RF filter 3 Gnd 4 Gnd Top View Pin Configuration - Single Ended Pin No. Label 1, 3, 4 6 Ground 2 Input 5 Output Ordering Information Part No. Description 857215 Packaged Part 857215-EVB Evaluation board Standard T/R size = 5000 units/reel DATA SHEET: October 2016 Rev. C - 1 of 6 - www.qorvo.com Subject to change without notice 857215 1090 MHz SAW Filter Absolute Maximum Ratings Parameter Rating (1) Storage Temperature 55 to +125C (2) Operable Temperature 55 to +85C (3) RF Input Power 15 dBm Notes: 1. Operation of this device outside the parameter ranges given may cause permanent damage. 2. Specifications are not guaranteed over all operable conditions 3. Input power with applied CW signal at +85C for 10K hours (1) Electrical Specifications (2) Test conditions unless otherwise noted: Temp = 55 to +85C (3) (4) Parameter Conditions Min Typical Max Units Center Frequency - 1090 - MHz Maximum Insertion Loss 1085 1095 MHz - 2.6 4.0 dB (5) Amplitude Variation 1085 1095 MHz - 0.2 1.25 dB p-p Group Delay Variation 1085 1095 MHz - 17.45 37 ns (6) 1.25 dB Lower Bandedge - 1079.39 1085 MHz 1.25 dB Upper Bandedge 1095 1100.89 1095 MHz 500 1006 MHz 54 61 - dB 1006 1040 MHz 50 61 - dB 1040 1050 MHz 48 52 - dB (7) Relative Attenuation 1140 1160 MHz 50 61 - dB 1160 1300 MHz 54 58 - dB 1300 1600 MHz 48 53 - dB (8) Source Impedance Single-ended - 50 - Ohms (8) Load Impedance Single-ended - 50 - Ohms Notes: 1. All specifications are based on the Qorvo schematics for the reference designs shown on page 3. 2. In production, devices will be tested at room temperature to a guard banded specification to ensure electrical compliance over temperature. 3. Electrical margin has been built into the design to account for the variations due to temperature drift and manufacturing tolerances. 4. Typical values are based on average measurements at room temperature 5. Amplitude Variation is defined as the difference between the lowest loss and the highest loss within defined frequency points 6. Relative to loss 1090 MHz 7. Relative to zero dB 8. This is the optimum impedance in order to achieve the performance shown DATA SHEET: October 2016 Rev. C - 2 of 6 - www.qorvo.com Subject to change without notice