857216 Qorvo

857216 1030 MHz SAW Filter General Description 857216 is a general purpose RF filter designed in a 3x3mm hermetic package SMP-12 3.00 X 3.00 X 1.22 mm Product Features Usable bandwidth 10 MHz High attenuation Low Loss Excellent power handling Single-ended operation No matching required for operation at 50 Functional Block Diagram Small Size: 3.00 x 3.00 x 1.22 mm Ceramic Surface Mount Package (SMP) Hermetically sealed 6 1 Gnd Gnd RoHS compliant, Pb-free P b Input Output 2 5 Applications General purpose RF filter 3 Gnd 4 Gnd Top View Pin Configuration - Single Ended Pin No. Label 1, 3, 4 6 Ground 2 Input 5 Output Ordering Information Part No. Description 857216 Packaged Part 857216-EVB Evaluation board Standard T/R size = 5000 units/reel DATA SHEET: October 2016 Rev. D - 1 of 6 - www.qorvo.com Subject to change without notice 857216 1030 MHz SAW Filter Absolute Maximum Ratings Parameter Rating (1) Storage Temperature 55 to +125C (2) Operable Temperature 55 to +85C (3) RF Input Power 15 dBm Notes: 1. Operation of this device outside the parameter ranges given may cause permanent damage. 2. Specifications are not guaranteed over all operable conditions 3. Input power with applied CW signal at +85C for 10K hours (1) Electrical Specifications (2) Test conditions unless otherwise noted: Temp = 55 to +85C (3) (4) Parameter Conditions Min Typical Max Units Center Frequency - 1030 - MHz Maximum Insertion Loss 1025 1035 MHz - 2.3 4.0 dB (5) Amplitude Variation 1025 1035 MHz - 0.18 1.25 dB p-p Group Delay Variation 1025 1035 MHz - 10.21 38 ns (6) 1.25 dB Lower Bandedge - 1020 1025 MHz 1.25 dB Upper Bandedge 1035 1041 - MHz 500 946 MHz 53 64 - dB 946 980 MHz 50 63 - dB 980 990 MHz 48 54 - dB (7) Relative Attenuation 1080 1100 MHz 50 66 - dB 1100 1250 MHz 54 59 - dB 1250 1600 MHz 47 53 - dB (8) Source Impedance Single-ended - 50 - Ohms (8) Load Impedance Single-ended - 50 - Ohms Notes: 1. All specifications are based on the Qorvo schematics for the reference designs shown on page 3. 2. In production, devices will be tested at room temperature to a guard banded specification to ensure electrical compliance over temperature. 3. Electrical margin has been built into the design to account for the variations due to temperature drift and manufacturing tolerances. 4. Typical values are based on average measurements at room temperature 5. Amplitude Variation is defined as the difference between the lowest loss and the highest loss within defined frequency points 6. Relative to loss 1030 MHz 7. Relative to zero dB 8. This is the optimum impedance in order to achieve the performance shown DATA SHEET: October 2016 Rev. D - 2 of 6 - www.qorvo.com Subject to change without notice