IDTF1653NLGI Datasheet ZIF/CIF Modulator 600MHz to 2900MHz FEATURES GENERAL DESCRIPTION Power Gain = 3dB This document describes specifications for the F1653NLGI I/Q Modulator implementing Zero- Direct 100 differential drive from Tx DAC TM Distortion technology for low power consumption with << 559900mmWW PPoowweerr CCoonnssuummppttiioonn improved ACLR. This device interfaces directly to a high performance dual DAC. -159 dBm/Hz Output Noise -161 dBc/Hz Internal LO Path Noise COMPETITIVE ADVANTAGE IP2 = +64 dBm 2GHz O In typical multi-mode, multi-carrier basestation transmitters the modulator has limited linearity and high IP3 = +36 dBm 2GHz IP3 = +36 dBm 2GHz OO power consumption which penalizes the system ACLR Excellent native LO and image suppression and system Power consumptions budgets in a Digital- Pre-Distortion environment. 600 MHz input 1dB Bandwidth The IDTF1653 is designed to eliminate these penalties by 600 MHz to 2900 MHz RF BW TM embedding Zero-Distortion technology into the device FFaasstt SSeettttlliinngg ffoorr TTDDDD ((<< 220000 nnsseecc)) such that very high IP3 and IP2 are achieved with minimal current draw. 3.3V Single Power Supply Power consumption 45% 45% LO port can be driven single ended or IM3 Distortion 14 dB 14 dB differential 4mm x 4mm, 24-pin TQFN package PART MATRIX RF freq Power DEVICE BLOCK DIAGRAM Part IP2 IP3 Noise O O Range Cons. +60 587 +36 -158 F1650 600 2400 dBm mW dBm dBm/Hz ++6644 558877 ++3366 --115599 F1653 600 2900 F1653 600 2900 ddBBmm mmWW ddBBmm ddBBmm//HHzz 0 90 TMTM Zero-Distortion Zero-Distortion ORDERING INFORMATION Omit IDT 0.8 mm height Tape & prefix package Reel IDTF1653NLGI8 Green RF product Line Industrial Temp range TM Zero-Distortion Modulator 1 RevO, April 2015 IDTF1653NLGI Datasheet ZIF/CIF Modulator 600MHz to 2900MHz ABSOLUTE MAXIMUM RATINGS VDD to GND -0.3V to +3.6V STBY -0.3V to (VDD + 0.3V) BB I+, BB I-, BB Q+, BB Q- -0.3V to 1.8V LO IN -0.3V to 0.3V RF OUT (VDD-0.35V) to (VDD-0.05V) Continuous Power Dissipation 1.5W (Junction Ambient) +45C/W JA (Junction Case) The Case is defined as the exposed paddle +2.5C/W JC Operating Temperature Range (Case Temperature) T = -40C to +105C CASE Maximum Junction Temperature 150C Storage Temperature Range -65C to +150C Lead Temperature (soldering, 10s) +260C Stresses above those listed above may cause permanent damage to the device. Functional operation of the device at these or any other conditions above those indicated in the operational section of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability TM Zero-Distortion Modulator 2 RevO, April 2015