DATASHEET
HA-5102, HA-5104
FN2925
Rev 9.00
Dual and Quad, 8MHz, Low Noise Operational Amplifiers
October 26, 2004
Low noise and high performance are key words describing
Pinouts
HA-5102 and HA-5104. These general purpose amplifiers
HA-5102 (CERDIP)
offer an array of dynamic specifications including a 3V/s
TOP VIEW
slew rate and 8MHz bandwidth. Complementing these
outstanding parameters is a very low noise specification of OUT1 1 8
V+
4.3nV/ Hz at 1kHz.
2 7
-IN1 OUT2
-
+
3 6 -IN2
+IN1
Fabricated using the Intersil high frequency DI process,
-
+
4 5
V- +IN2
these operational amplifiers also offer excellent input
specifications such as a 0.5mV offset voltage and 30nA
offset current. Complementing these specifications are
HA-5104 (CERDIP)
108dB open loop gain and 60dB channel separation. TOP VIEW
Consuming a very modest amount of power (90mW/
OUT1
1 14 OUT4
package for duals and 150mW/package for quads),
1 4
HA-5102/04 also provide 15mA of output current. -IN1
2 13 -IN4
- -
+ +
+IN1
3 12 +IN4
This impressive combination of features make this series of
V+ 4 11
V-
amplifiers ideally suited for designs ranging from audio
+IN2
amplifiers and active filters to the most demanding signal 5 10
+IN3
+ +
- -
conditioning and instrumentation circuits.
-IN2
6 9 -IN3
2 3
OUT2
7 8 OUT3
These operational amplifiers are available in dual or quad
form with industry standard pinouts allowing for immediate
interchangeability with most other dual and quad operational
HA5104 (SOIC)
amplifiers. TOP VIEW
HA-5102 Dual, Comp. HA-5104 Quad, Comp. OUT4
OUT1 1 16
14
-IN4
-IN1 2 15
- -
Refer to the /883 data sheet for military product.
+ +
+IN4
+IN1 3 14
V+ 4 13 V-
Ordering Information
+IN3
+IN2 5 12
+
+
TEMP. RANGE PKG. - -
-IN2 6 11 -IN3
o
PART NUMBER ( C) PACKAGE DWG. #
23
10
OUT2 7 OUT3
HA7-5102-2 -55 to 125 8 Ld CERDIP F8.3A
NC 8 9 NC
HA1-5104-2 -55 to 125 14 Ld CERDIP F14.3
HA9P5104-9 -40 to 85 16 Ld SOIC M16.3
Features
Low Noise. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4.3nV/Hz
Bandwidth. . . . . . . . . . . . . . . . . . . . 8MHz (Compensated)
Slew Rate . . . . . . . . . . . . . . . . . . . . 3V/s (Compensated)
Low Offset Voltage . . . . . . . . . . . . . . . . . . . . . . . . . 0.5mV
Available in Duals or Quads
Applications
High Q, Active Filters
Audio Amplifiers
Instrumentation Amplifiers
Integrators
Signal Generators
For Further Design Ideas, See Application Note AN554
FN2925 Rev 9.00 Page 1 of 13
October 26, 2004HA-5102, HA-5104
Absolute Maximum Ratings Thermal Information
o o
Supply Voltage Between V+ and V- Terminals . . . . . . . . . . . . . 40V Thermal Resistance (Typical, Note 2) ( C/W) ( C/W)
JA JC
Differential Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7V
8 Lead CERDIP Package. . . . . . . . . . . 115 28
Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . V
SUPPLY 14 Lead CERDIP Package. . . . . . . . . . 75 20
Output Short Circuit Duration (Note 3). . . . . . . . . . . . . . . . Indefinite
SOIC Package . . . . . . . . . . . . . . . . . . . 100 N/A
o
Maximum Junction Temperature (Note 1, Hermetic Package) . .175 C
o
Operating Conditions Maximum Junction Temperature (Plastic Package) . . . . . . . .150 C
o o
Maximum Storage Temperature Range . . . . . . . . . -65 C to 150 C
Temperature Range
o
Maximum Lead Temperature (Soldering 10s) . . . . . . . . . . . . 300 C
o o
HA-510X-2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -55 C to 125 C
(SOIC - Lead Tips Only)
o o
HA-5104-9 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -40 C to 85 C
CAUTION: Stresses above those listed in Absolute Maximum Ratings may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTES:
o
1. Maximum power dissipation, including output load, must be designed to maintain the maximum junction temperature below 175 C for hermetic
o
packages, and below 150 C for plastic packages.
2. is measured with the component mounted on a low effective thermal conductivity test board in free air. See Tech Brief TB379 for details.
JA
3. Any one amplifier may be shorted to ground indefinitely.
Electrical Specifications V = 15V, Unless Otherwise Specified
SUPPLY
HA-5102-2 HA-5104-2 HA-5104-9
TEMP.
o
PARAMETER ( C) MIN TYP MAX MIN TYP MAX MIN TYP MAX UNITS
INPUT CHARACTERISTICS
Offset Voltage 25 - 0.5 2.0 - 0.5 2.5 - 0.5 2.5 mV
Full -- 2.5 - - 3.0 -- 3.0 mV
o
Offset Voltage Average Drift Full - 3 - - 3 - - 3 - V/ C
Bias Current 25 - 130 200 - 130 200 - 130 200 nA
Full - - 325 - - 325 - - 500 nA
Offset Current 25 - 30 75 - 30 75 - 30 75 nA
Full - - 125 - - 125 - - 125 nA
Input Resistance 25 - 500 - - 500 - - 500 - k
Common Mode Range Full 12 - - 12 - - 12 - - V
TRANSFER CHARACTERISTICS
Large Signal Voltage Gain, 25 100 250 - 100 250 - 80 250 - kV/V
(V = 5V, R = 2k
OUT L
Full 100 - - 100 - - 80 - - kV/V
Common Mode Rejection Ratio (V = 5.0V) Full 86 95 - 86 95 - 80 95 - dB
CM
Small Signal Bandwidth, (A = 1) 25 - 8 - - 8 - - 8 - MHz
V
Channel Separation (Note 4) 25 - 60 - - 60 - - 60 - dB
OUTPUT CHARACTERISTICS
Output Voltage Swing (R = 10k )Full 12 13 - 12 13 - 12 13 - V
L
(R = 2k )Full 10 12 - 10 12 - 10 12 - V
L
Output Current, (V = 5V) Full 10 15 - 10 15 - 7 15 - mA
OUT
Full Power Bandwidth (Note 5) 25 16 47 - 16 47 - 16 47 - kHz
Output Resistance 25 - 110 - - 110 - - 110 -
STABILITY
Minimum Stable Closed Loop Gain Full 1 - - 1 - - 1 - - V/V
TRANSIENT RESPONSE (Note 6)
FN2925 Rev 9.00 Page 2 of 13
October 26, 2004