QS3861PAG8 Renesas

IDTQS3861 HIGH-SPEED CMOS 10-BIT BUS SWITCH WITH FLOW-THROUGH PINOUT INDUSTRIAL TEMPERATURE RANGE QUICKSWITCH PRODUCTS IDTQS3861 HIGH-SPEED CMOS 10-BIT BUS SWITCH WITH FLOW-THROUGH PINOUT DESCRIPTION: FEATURES: Enhanced N channel FET with no inherent diode to Vcc The QS3861 provides a set of ten high-speed CMOS TTL-compatible 5 bidirectional switches connect inputs to outputs bus switches. The low ON resistance (5) of the QS3861 allows inputs to Zero propagation delay, zero ground bounce be connected without adding propagation delay and without generating Undershoot clamp diodes on all switch and control inputs additional ground bounce noise. The Bus Enable (BE) signal turns the Available in QSOP and TSSOP packages switches on. The QS3861 is characterized for operation at -40C to +85C. APPLICATIONS: Hot-swapping, hot-docking Voltage translation (5V to 3.3V) Power Conservation Capacitance reduction and isloation Bus Isolation Clock Gating FUNCTIONAL BLOCK DIAGRAM A0 B0 A9 B9 BE The IDT logo is a registered trademark of Integrated Device Technology, Inc. INDUSTRIAL TEMPERATURE RANGE JANUARY 2013 1 c 2013 Integrated Device Technology, Inc. DSC-5767/6IDTQS3861 INDUSTRIAL TEMPERATURE RANGE HIGH-SPEED CMOS 10-BIT BUS SWITCH WITH FLOW-THROUGH PINOUT (1) PIN CONFIGURATION ABSOLUTE MAXIMUM RATINGS Symbol Description Max Unit (2) VTERM Supply Voltage to Ground 0.5 to +7 V 1 24 Vcc NC (3) VTERM DC Switch Voltage VS 0.5 to +7 V (3) A0 2 23 BE VTERM DC Input Voltage VIN 0.5 to +7 V VAC AC Input Voltage (pulse width 20ns) 3 V 3 22 B0 A1 IOUT DC Output Current 120 mA 4 21 B1 A2 PMAX Maximum Power Dissipation 0.5 W TSTG Storage Temperature 65 to +150 C A3 5 20 B2 NOTES: 6 19 B3 A4 1. Stresses greater than those listed under ABSOLUTE MAXIMUM RATINGS may cause permanent damage to the device. This is a stress rating only and functional operation 7 18 B4 A5 of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating B5 A6 8 17 conditions for extended periods may affect reliability. 2. VCC terminals. B6 A7 9 16 3. All terminals except VCC . A8 10 15 B7 B8 A9 11 14 CAPACITANCE (TA = +25C, f = 1MHz, VIN = 0V, VOUT = 0V) GND 12 13 (1) B9 Pins Typ. Max. Unit Control Inputs 3 5 pF Quickswitch Channels (Switch OFF) 5 7 pF QSOP/ TSSOP NOTE: TOP VIEW 1. This parameter is guaranteed but not production tested. PIN DESCRIPTION Pin Names Description A0 - A9 Bus A B0 - B9 Bus B BE Bus Switch Enable (1) FUNCTION TABLE BE A0 - A9 Function H Z Disconnect LB0 - B9 Connect NOTE: 1. H = HIGH Voltage Level L = LOW Voltage Level Z = High-Impedance 2