BH1792GLC-EVK-001

Users Guide Optical Sensor for Heart Rate Monitor BH1792GLC-EVK-001 Manual BH1792GLC-EVK-001 is an evaluation board for BH1792GLC, which is a ROHM Optical Sensor for Heart Rate Monitor. This Users Guide is 1 about how to use BH1792GLC-EVK-001 together with SensorShield* . *1 SensorShield is sold as a single unit of Shield-EVK-001 or as a part of SensorShield-EVK-002. J15 Preparation 4.VLED terminal 6.Pull-up setting pin 5.Interrupt setting pin Arduino Uno 1pc 3.Voltage setting pin Personal Computer installed Arduino IDE 1pc Requirement : Arduino 1.6.7 or higher Please use Arduino IDE which can be downloaded from the link below: BH1792GLC-EVK-001 Manual Users Guide 4. Select Tools -> Serial Plotter (Figure 5) Measurement 1. Select Tools and check the contents enclosed in the red frame. (Figure 3) Board is Arduino/Genuino Uno . Port is COMxx (Arduino/Genuino Uno) . COM port number is different in each environment. Figure 5. Tools Setting 5. Place finger on top of the sensor board. (Figure 6) Note: Be careful of static electricity. Figure 3. COM Port setting 2. Write the program by pressing right arrow button for upload (Figure 4) 3. Wait for the message Done uploading (Figure 4) Figure 6. Measurement Environment 6. Check log of Serial Plotter (Figure 7) Optical Sensor Data with LED ON Optical Sensor Data with LED OFF Figure 4. Uploading Figure 7. Serial Plotter 2017 ROHM Co., Ltd. No. 60UG056E Rev.001 2/3 JAN.2018