C8051F540DK Silicon Labs

P2 P3 DEBUG A DEBUG B P1 P5 TB1 J18 RESET B RESET A CP SIDE B P4 2102 SIDE A Port 2 A COMM P1.3 B P1.4 B P1.3 A DS1 DS1 U1 J13 J12 J11 J3 DS2 C8051 P1.4 A Port 1 A J14 F540 J8 J16 Port 1 B Port 0 B J2 Port 0 A J15 U2 J10 J9 J6 PWR LED J5 F542 Port 2 B J17 DS3 SILICON LABS J1 J4 www.silabs.com J7 C8051F540-TB J32 R22 TB3 C8051F54x C8051F540 DEVELOPMENT KIT USERS GUIDE 1. Relevant Devices The C8051F540 Development Kit is intended as a development platform for the microcontrollers in the C8051F54x MCU family. The target board included in this kit is provided with a pre-soldered C8051F540 MCU (QFN32 package) and a C8051F542 (QFN24 package). Code developed on the C8051F540 can be easily ported to the other members of this MCU family. Refer to the C8051F54x data sheet for the differences between the members of this MCU family. 2. Kit Contents The C8051F540 Development Kit contains the following items: C8051F540 Target Board C8051Fxxx Development Kit Quick-Start Guide AC to DC Power Adapter USB Debug Adapter (USB to Debug Interface) Two USB Cables 3. Hardware Setup Refer to Figure 1 for a diagram of the hardware configuration. 1. Connect the USB Debug Adapter to the DEBUG A connector on the target board with the 10-pin ribbon cable. 2. Connect one end of the USB cable to the USB connector on the USB Debug Adapter. 3. Verify that shorting blocks are installed on the target board as shown in Figure 5 on page 7. 4. Connect the other end of the USB cable to a USB Port on the PC. 5. Connect the ac/dc power adapter to power jack P1 on the target board. USB Debug Adapter Target Board USB Cable AC/DC Adapter +LIN V LIN LIN OUT GND LIN Figure 1. Hardware Setup using a USB Debug Adapter Rev. 0.2 6/15 Copyright 2015 by Silicon Laboratories C8051F54x Silicon Laboratories USB DEBUG ADAPTER Run Stop PowerC8051F54x Notes: Use the Reset icon in the IDE to reset the target when connected during a debug session. Remove power from the target board and the USB Debug Adapter before connecting or disconnecting the ribbon cable from the target board. Connecting or disconnecting the cable when the devices have power can damage the device and/or the USB Debug Adapter. 4. Software Setup Simplicity Studio greatly reduces development time and complexity with Silicon Labs EFM32 and 8051 MCU products by providing a high-powered IDE, tools for hardware configuration, and links to helpful resources, all in one place. Once Simplicity Studio is installed, the application itself can be used to install additional software and documentation components to aid in the development and evaluation process. Figure 2. Simplicity Studio The following Simplicity Studio components are required for the C8051F540 Development Kit: 8051 Products Part Support Simplicity Developer Platform Download and install Simplicity Studio from www.silabs.com/8bit-software or www.silabs.com/simplicity-studio. Once installed, run Simplicity Studio by selecting Start Silicon LabsSimplicity Studio Simplicity Studio from the start menu or clicking the Simplicity Studio shortcut on the desktop. Follow the instructions to install the software, and click Simplicity IDE to launch the IDE. The first time the project creation wizard runs, the Setup Environment wizard will guide the user through the process of configuring the build tools and SDK selection. In the Part Selection step of the wizard, select from the list of installed parts only the parts to use during 2 Rev. 0.2