CENB1030
Universal 30 Watt Series
ITE Switch-Mode Power Supply 3 Year Warranty
100-240VAC Universal Input
Meets EISA2007, CEC Efficiency Level V,
EU (EC) No 278/2009 Phase II
nd
Certified to UL/EN60950-1, 2 Edition
5Vto 48V outputs, up to 32W
Modified and Custom Designs Available
Regulated Output with Low Ripple
Impact-Resistant Polycarbonate Enclosure
No load Power Consumption <0.3W
Limited Power Source
Desktop & Wall Plug Styles
RoHS LPS
Specifications All Specifications are typical at nominal input, full load at 25 C unless otherwise stated.
MTBF >100,000 hours calculated
AC Input 100-240VAC, -/-10%, 47-63 Hz, 1
Input Current 100VAC: 0.9A Hold-up Time 18 ms min. @ 115VAC, 60 msec @ 230VAC
Inrush Current 60A peak, 264Vac, cold start Turn-on Time 2 seconds, max.
Input Fuse 3.15A Internal Primary Current Fuse is provided Topology Switching Fixed Frequency Flyback
Efficiency Meets EISA2007, CEC Efficiency Level V, Overload Protection Hiccup Mode
and EU(EC) No. 278/2009 Phase II requirements
Output Voltage See chart Short Circuit Protection Hiccup Mode
Output Power See chart EMC See chart below
Ripple and Noise 1% pk-pk max., 20MHz BW Safety Standards EN/IEC/CSA/UL60950-1, 2nd Edition, LPS
Line & Load Voltage Regulation Line: +/- 1%, Load: +/-5% Dielectric Withstand Input-Output: 4,242VDC, Input-GND: 1,500 Vac,
Output-GND: 500Vdc
Transient Response 500s max., 50% load step, typical
Operating Temperature 0 to 40C, no derating
Minimum Load Not required
Storage Temperature -40 to +85C
Case Material: Black 94V0 Polycarbonate Relative Humidity 5% to 95%, non-condensing
Case Dimensions: 95 x 54 x 31mm. See outline drawing Altitude 0 to 10,000 ft
Weight = 200g
Output Connector: 2.5mm barrel type (Ault #3) connector, Output Cable: 5V 9V models: #18AWG (SPT-1), 1,500mm, 2 conductor
center contact (+). Other options available 12V 48V models: #18AWG (UL1185), 1,500mm, 2 conductor
EMC Specifications
Conducted Emissions
EN55022 Class B, FCC Part 15, Class B.
Radiated Emissions EN55022 Class B, FCC Part 15, Class B.
Line Frequency Harmonics EN61000-3-2, Class A
Voltage Fluctuations/Flicker EN61000-3-3
Static Discharge Immunity EN61000-4-2, 6kV Contact Discharge, 8kV air discharge
Radiated RF Immunity EN61000-4-3, 3V/m.
EFT/Burst Immunity EN61000-4-4, 2kV/5kHz.
Line Surge Immunity EN61000-4-5, 1kV differential, 2kV common-mode
Conducted RF Immunity EN61000-4-6, 3Vrms
Power Frequency Magnetic Field Immunity EN61000-4-8, 3A/m
Voltage Dip Immunity EN61000-4-11, Criteria B
______________________________________________________________________________________________________________________________ 1 of 2
SL Power Electronics Corp 6050 King Drive Ventura, CA 93003 Phone 805.486.4565 Fax 858.712.2040 Email: info@slpower.com www.slpower.comCENB1030
Universal 30 Watt Series
ITE Switch Mode Power Supply 3 Year Warranty
Model Number Volts (V) Output Current (max) Max Watts Ripple (Vp-p max)
CENB1030A0503F01 5 V 4.00 A 20.0 W 50 mV
CENB1030A0703F01 7.5 V 3.00 A 22.5 W 75 mV
CENB1030A0903F01 9 V 3.00 A 27.0 W 90 mV
CENB1030A1203F01 12 V 2.50 A 30.0 W 120 mV
CENB1030A1403F01 14 V 2.10 A 29.4 W 140 mV
CENB1030A1503F01 15 V 2.00 A 30.0 W 150 mV
CENB1030A1803F01 18 V 1.67 A 30.0 W 180 mV
CENB1030A2403F01 24 V 1.33 A 31.9 W 240 mV
CENB1030A4803F01 48 V 0.67 A 32.1 W 480 mV
Notes: Part numbers above include #3 output connector and IEC320 C14 grounded input receptacle. See below for other options.
Model Number Key
CENB 1 030 A VV 03 F 01
Model01" = Standard.02" and higher indicates a modified model.
Input Connector: = IEC320 C14 grounded, Other options available, see below
Output Connector:03" = 2.5mm Barrel Type Connector. Other options available, contact factory.
Output Voltage:05" = 5Vdc,12" = 12Vdc,24" = 24Vdc, etc.
Model = Original Configuration
Output Power:030" = 30 Watts
# of Outputs1" = Single Output
Product Family: = Commercial/ITE/Industrial, = External,N = Model Series Designator
AC Input Receptacle Options Output Connector
Desktop Wall-Plug
IEC320 - C14 IEC320 - C18 IEC320 - C8 N. America N. America Europe United Australia
Class I Class II Class II Japan Japan Kingdom
Grounded Ungro undedShave Interchangable Fixed Fixed Fixed Fixed
(F) (Q) (N) (C) (B) (M) (G) (H)
Notes:
1. For desktop options, choose applicable letter above. Notes: 1. Ault #3 Connector, center contact (+).
2. For Wall-Plug options, choose the applicable letter above and the unit will be fitted with 2. Connector is Switchcraft 760 plug or equivalent.
the receptacle chosen. The N. A. blade version (C) will be an interchangeable blade. Mating connector is Switchcraft 712A or equivalent.
The other options (B), (M), (G), and (H) will be fixed blades molded in the case. 3. Other connector options are available. Contact your local
3. Blade Kit is available which will include one each of a EU, UK, and Australian blade. Kit part # SL Power Representative for details.
is KT1027K. These can be used with the (C) version, to allow blades to be changed.
Outline Drawings
DATE
CODE
Desktop Style Wall-plug Style C Option Shown (with KT1027K interchangeable blade kit)
Data Sheet 2014 SL Power Electronics Corp. The information and specifications contained herein are believed to be correct at the time of publication. Rev. 9-22-14
However, SL Power accepts no responsibility for consequences arising from reproduction errors or inaccuracies. Specifications are subject to change without notice.
______________________________________________________________________________________________________________________________ 2 of 2
SL Power Electronics Corp 6050 King Drive Ventura, CA 93003 Phone 805.486.4565 Fax 858.712.2040 Email: info@slpower.com www.slpower.com