CINT1275A2414K01 SL Power

275W Single Output 275W Single Output CINT1275 Family CINT1275 Family Industrial Grade Industrial Grade FEATURES AND BENEFITS 3 x 5 x 1.40 Package Inhibit, Power Fail, Output OK Signals Industrial Up to 275W of AC-DC Power Approved to EN/CSA/IEC/UL62368-1 For 1U Applications Efficiency 92% Typical Universal Input 90-264VAC Input Range 3 Years Warranty Standby and Fan Output Voltages RoHS Compliant Forced Current Share MODEL SELECTION Output Current Total Ripple & OVP Fan Output Model Number Volts ** *** Regulation Noise Threshold w/200LFM air Convection* 120mV pk-pk CINT1275A1214K01 12V 21.8A 15.0A 12V DC/1A 3% 14.0 1.1V CINT1275A1514K01 15V 18.3A 12.0A 12V DC/1A 150mV pk-pk 3% 19.5 1.5V CINT1275A2414K01 24V 10.9A 7.50A 12V DC/1A 240mV pk-pk 3% 28.0 2.5V CINT1275A4814K01 48V 5.46A 3.75A 12V DC/1A 480mV pk-pk 3% 55.0 4.0V CINT1275A5614K01 4.68A 3.21A 12V DC/1A 560mV pk-pk 3% 59.0 1.0V 56V Note: * Total convection power is 180 Watts. ** Measured with noise probe directly across output terminals, and load terminated with 0.1F ceramic and 10F low ESR capacitors. *** No output adjustment on 56V. INPUT OUTPUT 100-240VAC, 10%, 47-63Hz, 1 Hold-Up Time 16ms at 250W, 120VAC/60Hz AC Input 120-370V DC Less than 2 sec 115VAC (inversely proportional to 115VAC: 3A, 230VAC: 1.5A Turn On Time Input Current input voltage and thermistor temperature) 3.7A max at 90VAC PFC: Variable, 30kHz - 400kHz Switching Inrush Current 264VAC, cold start: will not exceed 50A Main converter: Variable 30-250kHz, 65-70kHz at Frequency full load Input Fuses F1, F2: 5A, 275VAC fuses provided on all models 275W continuous, with 200 LFM airflow, 180W Earth Leakage Output Power convection cooled - See chart for specific voltage <750A 264VAC, 60Hz, NC Current model ratings Efficiency 92% typical Output Voltage See chart Ripple and Noise 0.5%rms, 1% pk-pk, See chart 500S typical, Return to 0.5% of nominal, 50% load SAFETY Transient Response step Di/Dt: <0.2A/S. Max voltage deviation = 3% Safety Standards EN/CSA/IEC/UL62368-1 Voltage Adjustability +/-5% from nominal (except 56V) Operating: Half-sine, 20gpk, 10ms, 3 axes, 6 shocks total Not required Minimum Load Shock Non-operating: Half-sine, 40gpk, 10ms, 3 axes, 6 shocks Total Regulation +/- 3% combined line, load and initial setting total CINT1275 Family Datasheet v0920 Copyright 20 20 SL Power Electronics Corp. All rights reserved. Page 1 CINT1275 Family Datasheet v0819 Copyright 2019 SL Power Electronics Corp. All rights reserved.275W Single Output 275W Single Output 275W Single Output CINT1275 Family CINT1275 Family CINT1275 Family Industrial Grade Industrial Grade Industrial Grade PROTECTION RELIABILITY Overtemperature Sensing transformer temperature, 135C MTBF 4,65,000 hours, 275W load, 110VAC input, 25C ambient (55C ambient temperature at full load), Latching type Protection 120 to 150% of rating, Hiccup mode Overload Protection Short Circuit Hiccup mode, Auto recovery ISOLATION SPECIFICATION Protection Overvoltage OVP latch at 110 to 130% of output voltage Input-Output: 4,000VAC Protection Input-Ground: 1,800VAC Isolation Output-Ground: 1,500VAC ENVIRONMENT AUXILIARY SIGNALS Operating -10C to +70C Temperature Start up at -40C, Full load Standby Output 5V 200mA Temperature Derating Derate output power linearly above 50C to 50% at 70C Goes LOW with 5ms warning before loss of DC output AC Power Fail Storage Temperature -40C to +85C after loss of AC power Operating: -500 to 10,000 ft Connect to inhibit pin (J201 pin 5) to output common Altitude Inhibit Non-operating: -500 to 40,000 ft to inhibit the DC output Relative Humidity 5% to 95%, Non-condensing Remote Sense Compensates for up to 250mV drop in load lines Operating: 0.003g/Hz, 1.5grms overall, 3 axes, Open collector logic signal goes and stays HIGH DC OK 10 min/axis 100ms to 500ms after main output reaches regulation Vibration Non-operating: 0.026g2/Hz, 5.0grms overall, 3 axes, Fan Output 12V 1A 1 hr/axis Forced current sharing provided for up to 5 units W: 3.0 x L: 5.0 x H: 1.40 (from bottom of PC board) Dimensions Current Share connected in parallel Weight 325g EMI/EMC COMPLIANCE EN55011/22 Class B, FCC Part 15, Subpart B, Class B Conducted Emissions EN55011/22 Class A, FCC Part 15, Subpart B, Class A w/6db margin Radiated Emissions Static Discharge Immunity EN61000-4-2, 6kV contact discharge, 8kV air discharge Radiated RF Immunity EN61000-4-3, 3V/m EFT/Burst Immunity EN61000-4-4, 2kV/5kHz Line Surge Immunity EN61000-4-5, 1kV differential, 2kV common-mode Conducted RF Immunity EN61000-4-6, 3Vrms Power Frequency Magnetic Field EN61000-4-8, 3A/m Immunity Voltage Dip Immunity EN61000-4-11, 100%, 10ms 30%, 275ms 60%, 100ms Performance Criteria A, A, & A at 70% load EN61000-3-2, Class A, B, C, & D Line Harmonic Emissions Flicker Test EN61000-3-3, Complies (dmax<6%) CINT1275 Family Datasheet v0819 Copyright 2019 SL Power Electronics Corp. All rights reserved. CINT1275 Family Datasheet v0920 Copyright 20 20 SL Power Electronics Corp. All rights reserved. Page 2 CINT1275 Family Datasheet v0819 Copyright 2019 SL Power Electronics Corp. All rights reserved.