TF800A15K SL Power

800W Single Output 800W Single Output TF800 Family TF800 Family Industrial Grade Industrial Grade FEATURES AND BENEFITS 800W Fan-Cooled (Load & Temperature Remote Setting Multiple PSU via RS232, Controlled) RS485 & IC Industrial Programmable Output Voltage (0% ~ 105%) Power OK Signal Approved to EN/CSA/IEC/UL62368-1 Remote ON/OFF, Remote Sense Function Forced Current Sharing at Parallel Operation Protection: OVP, OLP, OTP, Fan Failure Constant Current Limit Global Control via RS232 Selectable +5V/0.5A or +9V/0.3A Auxiliary Output MODEL SELECTION Output Rated Current Output Ripple & Line Load Voltage 4 Model Number Efficiency 1 3 Volts Current Range Power Noise Regulation Regulation Tolerance TF800A12K 12V 66.7A 0-66.7A 800W 150mV pk-pk 1% 1% 2% 89% TF800A15K 15V 53.4A 0-53.4A 800W 150mV pk-pk 1% 1% 2% 90% TF800A24K 24V 33.5A 0-33.5A 800W 240mV pk-pk 1% 1% 2% 92% TF800A48K 48V 16.37A 0-16.7A 800W 480mV pk-pk 1% 1% 2% 92% TF800A60K 60V 13.4A 0-13.4A 800W 600mV pk-pk 1% 1% 2% 93% Notes : 1. See CMD VS Output Curve. 4. Other output voltages available, consult factory. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12 twisted 5. Recovery after reset AC power ON or inhibit. pair-wire terminated with a 0.1uF & 47uF parallel capacitor. 6. All specifications are typical at 230Vac, full load, at 25C ambient unless noted. 3. Tolerance: includes setup time tolerance, line regulation and load regulation. INPUT OUTPUT Output Voltage See Model Selection Table on pg 1 Input Voltage and 100-240Vac, 10%, 47-63Hz, 1127-370Vdc 1 Frequency 1 800W continuous See model selection Output Power table for specific voltage model ratings Input Current 115Vac: 9.3A, 230Vac: 3.7A Voltage Range 5.0% Typical adjustment by potentiometer (VR1) Inrush Current 30A/115VAC, 60A/230VAC Efficiency See Model Selection Table Voltage Tolerance See Model Selection Table on pg 1 Power Factor 0.95/230VAC, 0.98/115VAC at full load Hold-Up Time 11mS/230VAC at full load Leakage Current < 1mA/240VAC 800ms Turn On Time 100ms at full load Rise Time De-rating may apply in low input voltage. Please check the de-rating Notes : 1. curve for more details Ripple and Noise See Model Selection Table on pg 1 Line/Load Regulation See Model Selection Table on pg 1 De-rating may apply in low input voltage. Please check the de-rating Notes : 1. curve for more details CONNECTOR INFORMATION Input Connector Output Connector Signal Connector Term. 1) AC LINE Pinout: Term. 2) NEUTRAL + and - See Signal Connector Table on pg 3 Term. 3) GROUND Mating Connector Connector: JST PHDR-24VS or equivalent 10 wire lugs M6 Wire Lugs /terminal: Pins: JST SPHD-002T-P0.5 or equivalent TF800 Family Datasheet v0920 Copyright 2020 SL Power Electronics Corp. All rights reserved. Page 1 TF800 Family Datasheet v0819 Copyright 2019 SL Power Electronics Corp. All rights reserved.800W Single Output 800W Single Output 800W Single Output TF800 Family TF800 Family TF800 Family Industrial Grade Industrial Grade Industrial Grade AUXILIARY SIGNALS EMI/EMC COMPLIANCE Conducted Emissions Certified EN 55022 EN 61204-3 EN 61000-6-3 Selectable +5V/0.5A or +9V/0.3A auxiliary Auxiliary Power output Radiated Emissions Certified EN 55022 EN 61204-3 EN 61000-6-3 Remote ON / OFF Electro-Static Discharge By external switch Control (ESD) Immunity on Power EN55024/IEC61000-4-2 ports Open drain signal low when PSU turns on, Max. Power OK Signal sink current: 20mA, Max. drain voltage: 40V Radiated RF EM Fields EN55022/EN61000-4-3 Susceptibility Adjustment of output voltage is between Output Voltage Trim 0 ~ 105% of rated output Electrical Fast EN55024/IEC61000-4-4 Transients (EFT) /Bursts Adjustment of output current is between Output Current Trim 0 ~ 105% of rated output Surges, Line to Line EN55024/IEC61000-4-5 (Diff Mode) and Line to Please refer to Current Sharing with Remote GND (CMN Mode) 1 Parallel (Current Sharing) Sensing (Parallel Connection) Diagram Conducted Disturbances EN55022/IEC61000-4-6 Notes : 1. In parallel connection only one unit will operate if the total output load is induced by RF Fields less than 5% of the rated power. Rated Power frequency EN55024/IEC1000-4-8 magnetic fields PROTECTION Voltage Interruptions, EN55024/IECEN61000-4-11 Dips, Sags & Surges 120 7% of Vout, Latch Type (Recovery after Harmonic Current EN61000-3-2 Overvoltage Protection reset AC power ON or inhibit). (Refer to VCI vs. Emissions OVP Curve). Flicker Test EN61000-3-3 Short Circuit Protection Constant current, auto-recovery Notes : 1. The power supply is considered a component which will be installed Overtemperature into a final equipment. The final equipment must be re-confirmed that it 855C measured on NTC. Auto recovery Protection till meets EMC directives. Overload Protection 105% of rated power, constant current type SAFETY Safety Certifications Approved to EN/CSA/IEC/UL62368-1 ISOLATION SPECIFICATIONS Input-Output: 3000Vac 1 Input-Ground: 1500Vac Isolation Output-Ground : 500Vac RELIABILITY Isolation Resistance I/P-O/P, I/P-FG, O/P-FG: 100M Ohms/500VDC MTBF >112,000 hours per MIL-HDBK-217F Notes : 1. This test is done without enclosure: I/P-O/P 4242VDC. If with enclosure: I/P-O/P 2121VDC,I/P-FG:2121VDC, O/P-FG: 707VDC ENVIRONMENT Operating Temperature -25 ~ +60C (Refer to load de-rating curve) Temperature Derating See Derating Curve Vibration 10 ~ 500Hz, 2G 10min./1 cycle, period for 60min. each along X, Y, Z axes Compliance to IEC 68-2-6, IEC 68-2-64 Dimensions 127 x 41 x 249mm. 5.0 x 1.6 x 9.80 inch CoolingCooling Load and temperature control fan Relative Humidity 20% to 90%, non-condensing Storage Temperature and Humidity -40 ~ +85C, 10 ~ 95% RH Weight & Packing 1.7kg 6pcs/carton, 11.2kg/0.55CUFT TF800 Family Datasheet v0819 Copyright 2019 SL Power Electronics Corp. All rights reserved. TF800 Family Datasheet v0920 Copyright 20 20 SL Power Electronics Corp. All rights reserved. Page 2 TF800 Family Datasheet v0819 Copyright 2019 SL Power Electronics Corp. All rights reserved.