STEVAL-IPM05F Data brief 500 W motor control power board based on STGIF5CH60TS-L SLLIMM 2nd series IPM Features Input voltage: 125 - 400 V DC Nominal power: up to 500 W Nominal current: up to 3.0 A Input auxiliary voltage: up to 20 V DC Single or three-shunt resistors for current sensing (with sensing network) Two options for current sensing: dedicated op-amps or through MCU Overcurrent hardware protection IPM temperature monitoring and protection Hall sensor or encoder input nd Uses the STGIF5CH60TS-L IGBT intelligent power module from the 2 series of SLLIMM IPMs 32-pin motor control connector for interfacing with ST MCU boards Universal conception for further evaluation with breadboard and testing pins Very compact size RoHS compliant Description The STEVAL-IPM05F is a compact motor drive power board based on the SLLIMM nd (small low-loss intelligent molded module) 2 series product, STGIF5CH60TS-L. It provides an affordable and easy-to-use solution for driving high power motors for a Product summary wide range of applications such as white goods, air conditioning, compressors, power fans, high-end power tools and generally 3-phase inverters for motor drives. The IPM STEVAL-IPM05F itself consists of short-circuit rugged IGBTs and a wide range of features including compact motor drive STEVAL-IPM05F power board undervoltage lockout, smart shutdown, temperature sensing and NTC, and overcurrent protection. STGIF5CH60TS-L SLLIMM 2nd series STGIF5CH60TS-L The main characteristics of this evaluation board are its small size, minimal BOM and IPM high efficiency. It consists of an interface circuit (BUS and Vcc connectors), bootstrap capacitors, snubber capacitor, hardware short-circuit protection, fault event signal and temperature monitoring. In order to increase flexibility, it has been designed to work in single or three-shunt configuration and with double current-sensing options such as using three dedicated on-board op-amps, or op-amps embedded in the MCU. The Hall/Encoder part completes the circuit. Thanks to these advanced characteristics, the system has been specifically designed to achieve fast and accurate current feedback conditioning, satisfying the typical requirements for field-oriented control (FOC). The STEVAL-IPM05F is compatible with STs STM32-based control board, enabling designers to build a complete platform for motor control. DB2717 - Rev 5 - September 2019 www.st.com For further information contact your local STMicroelectronics sales office.STEVAL-IPM05F Schematic diagrams 1 Schematic diagrams Figure 1. STEVAL-IPM05F circuit schematic (1 of 6) STEVAL-IPMnmx decoder RC1 RC2 RC3 RC4 N 0 0 0 0 RC5 RC6 RC7 RC8 M 0 0 0 0 RC9 RC10 X 0 0 DB2717 - Rev 5 page 2/9