STEVAL-IPM07F Data brief 700 W motor control power board based on STGIF7CH60TS-L SLLIMM 2nd series IPM Features Input voltage: 125 - 400 V DC Nominal power: up to 700 W Nominal current: up to 4.2 A Input auxiliary voltage: up to 20 V DC Single or three-shunt resistors for current sensing (with sensing network) Two options for current sensing: dedicated op-amps or through MCU Overcurrent hardware protection IPM temperature monitoring and protection Hall sensor or encoder input Uses the STGIF7CH60TS-L IGBT intelligent power module from the SLLIMM nd 2 series IPMs Motor control connector (32-pin) interfacing with ST MCU boards Universal conception for further evaluation with bread board and testing pins Very compact size Description The STEVAL-IPM07F is a compact motor drive power board based on the small low- nd loss intelligent molded module SLLIMM 2 series product (STGIF7CH60TS-L) . It provides an affordable and easy-to-use solution for driving high power motors for a wide range of applications such as power white goods, air conditioning, compressors, Product summary power fans, high-end power tools and 3-phase inverters for motor drives in general. The IPM itself consists of short-circuit rugged IGBTs and a wide range of features like STEVAL-IPM07F undervoltage lockout, smart shutdown, internal temperature sensor and NTC, and compact motor drive STEVAL-IPM07F overcurrent protection. The main characteristics of this evaluation board are small power board size, minimal BOM and high efficiency. It includes an interface circuit (BUS and Vcc STGIF7CH60TS-L connectors), bootstrap capacitors, snubber capacitor, hardware short-circuit SLLIMM 2nd series STGIF7CH60TS-L protection, fault event signaling and temperature monitoring. In order to increase the IPM flexibility, it is designed to work in single- or three-shunt configurations and with two current sensing options: either three dedicated onboard op-amps or with op-amps embedded on the MCU. The Hall/Encoder part completes the circuit. Thanks to these advanced characteristics, the system is able to achieve fast and accurate current feedback conditioning, meeting most of the requirements for field oriented control (FOC). The STEVAL-IPM07F is compatible with STs STM32-based control board, for a complete motor control platform. DB2745 - Rev 4 - September 2019 www.st.com For further information contact your local STMicroelectronics sales office.STEVAL-IPM07F Schematic diagram 1 Schematic diagram Figure 1. STEVAL-IPM07F circuit schematic (1 of 6) STEVAL-IPMnmx decoder RC1 RC2 RC3 RC4 N 0 0 0 0 RC5 RC6 RC7 RC8 M 0 0 0 0 RC9 RC10 X 0 0 DB2745 - Rev 4 page 2/9