STEVAL-IPM10F Data brief 1000 W motor control power board based on STGIF10CH60TS-L SLLIMM 2nd series IPM Features Input voltage: 125 - 400 V DC Nominal power: up to 1000 W Nominal power: up to 6 A Input auxiliary voltage: up to 20 V DC Single- or three- shunt resistors for current sensing (with sensing network) Two options for current sensing: dedicated op-amps or through MCU Overcurrent hardware protection IPM temperature monitoring and protection Hall sensor or encoder input nd Uses the STGIF10CH60TS-L IGBT intelligent power module from the 2 series of SLLIMM IPMs Motor control connector (32-pin) to interface with ST MCU boards Universal conception for further evaluation with breadboard and testing pins Very compact size RoHS compliant Description The STEVAL-IPM10F is a compact motor drive power board based on the SLLIMM nd (small low-loss intelligent molded module) 2 series module STGIF10CH60TS-L. It provides an affordable and easy-to-use solution for driving high power motors for a Product summary wide range of applications such as white goods, air conditioners, compressors, power fans, high-end power tools, and generally 3-phase inverters for motor drives. STEVAL-IPM10F The IPM itself consists of short-circuit rugged IGBTs and a wide range of features compact motor drive STEVAL-IPM10F power board such as undervoltage lockout, smart shutdown, temperature sensing and NTC inside, and overcurrent protection. STGIF10CH60TS-L STGIF10CH60TS- SLLIMM 2nd The main characteristics of this evaluation board are its small size, minimal BOM and L series IPM high efficiency. It consists of an interface circuit (BUS and V connectors), bootstrap CC capacitors, snubber capacitor, hardware short-circuit protection, fault event signal, and temperature monitoring. In order to increase its flexibility, it was designed to work in single or three shunt-configuration and with double current sensing options such as three dedicated op-amps on-board, or op-amps embedded on the MCU. A Hall/ Encoder part completes the circuit. Thanks to these advanced characteristics, the system has been specifically designed to achieve accurate and fast conditioning of the current feedback, matching the typical requirements for field-oriented control (FOC). The STEVAL-IPM10F is compatible with STs STM32-based control board, providing a complete platform for motor control. DB2743 - Rev 4 - September 2019 www.st.com For further information contact your local STMicroelectronics sales office.STEVAL-IPM10F Schematic diagram 1 Schematic diagram Figure 1. STEVAL-IPM10F circuit schematic (1 of 6) STEVAL-IPMnmx decoder RC1 RC2 RC3 RC4 N 0 0 0 0 RC5 RC6 RC7 RC8 M 0 0 0 0 RC9 RC10 X 0 0 DB2743 - Rev 4 page 2/9