VNQ690SPTR-E STMicroelectronics

VNQ690SP-E QUAD CHANNEL HIGH SIDE DRIVER Figure 1. Package Table 1. General Features Type R I V DS(on) out CC VNQ690SP-E 90m (*) 10A 36V (*) Per each channel OUTPUT CURRENT PER CHANNEL: 10A CMOS COMPATIBLE INPUTS OPEN LOAD DETECTION (OFF STATE) UNDERVOLTAGE & OVERVOLTAGE 10 n SHUT- DOWN OVERVOLTAGE CLAMP 1 THERMAL SHUT-DOWN PowerSO-10 CURRENT LIMITATION VERY LOW STAND-BY POWER DISSIPATION PROTECTION AGAINST: n LOSS OF GROUND & LOSS OF V CC REVERSE BATTERY PROTECTION (**) IN COMPLIANCE WITH THE 2002/95/EC EUROPEAN DIRECTIVE DESCRIPTION The VNQ690SP-E is a monolithic device made by using STMicroelectronics VIPower M0-3 Technology, intended for driving resistive or inductive loads with one side connected to ground. This device has four independent channels. Built-in thermal shut down and output current limitation protect the chip from over temperature and short circuit. Table 2. Order Codes Package Tube Tape and Reel PowerSO-10 VNQ690SP-E VNQ690SPTR-E Note: (**) See application schematic at page 9 September 2013 DocID10883 Rev2 1/20VNQ690SP-E Figure 2. Block Diagram V CC OVERVOLTAGE UNDERVOLTAGE DEMAG 1 DRIVER 1 OUTPUT 1 I LIM1 INPUT 1 DEMAG 2 INPUT 2 DRIVER 2 OUTPUT 2 I LIM2 INPUT 3 LOGIC DEMAG 3 DRIVER 3 INPUT 4 OUTPUT 3 I LIM3 STATUS STATUS DEMAG 4 DRIVER 4 OUTPUT 4 OVERTEMP. 1 I LIM4 OVERTEMP. 2 OPEN LOAD OVERTEMP. 3 OFF-STATE OVERTEMP. 4 GND Table 3. Absolute Maximum Ratings Symbol Parameter Value Unit V Supply voltage (continuous) 41 V CC -V Reverse supply voltage (continuous) -0.3 V CC I Output current (continuous), per each channel Internally limited A OUT I Reverse output current (continuous), per each channel -15 A R I Input current +/- 10 mA IN I Status current +/- 10 mA STAT I Ground current at T <25C (continuous) -200 mA GND C Electrostatic Discharge (Human Body Model: R=1.5K C=100pF) - INPUT 4000 V V - STATUS 4000 V ESD - OUTPUT 5000 V - V 5000 V CC P Power dissipation at T =25C78W tot C Maximum Switching Energy E 53 mJ MAX (L=0.38mH R =0 V =13.5V T =150C I =14A) L bat jstart L T Junction operating temperature -40 to 150 C j T Storage temperature -65 to 150 C stg 2/20