X-NUCLEO-IOD02A1 STMicroelectronics

X-NUCLEO-IOD02A1 Data brief Dual channel IO-Link device expansion board based on L6364Q for STM32 Nucleo Features Based on the L6364Q IO-Link device dual transceiver in QFN package with the following main characteristics: 2-channel (CQ and DIO) IO-Link PHY layer IO-Link DLL (M-sequence handler and checksum) Wake-up detection Interrupt diagnostic pin SPI and UART interfaces 50 mA 3.3 V and 5.0 V linear regulators 50 mA adjustable (5.0 10.8 V) buck converter Overload protection with adjustable intervention threshold Overheating protection with adjustable shutdown threshold Full reverse polarity on process side Ground and V wire break protections CC QFN-20L (4 x 4 x 0.9 mm) package 5 to 35 V operating voltage range Red LED and green LED for status diagnostics Radiated Emissions (EM Fields 30 MHz-1 GHz) < 40dB V/m Immunity to conducted disturbance (150 kHz-80 MHz) 10 V Immunity to RF EM Fields (80 MHz-1 GHz) 10 V/m Immunity to RF EM Fields (1 GHz-2.7 GHz) 3 V/m Product summary Immunity to SURGE pulse (500 Ohm coupling) 1.2 kV Immunity to ESD contact/air 3 kV Dual channel IO- Link device Immunity to BURST noise 1 kV expansion board X-NUCLEO-IOD02A1 Compatible with STM32 Nucleo development boards based on L6364Q for Equipped with Arduino UNO R3 connectors STM32 Nucleo RoHS and WEEE compliant Industrial digital output software X-CUBE-IOD02 expansion for Description STM32Cube The X-NUCLEO-IOD02A1 expansion board for STM32 Nucleo is based on the Dual channel SIO L6364Q dual channel SIO and IO-Link PHY device transceiver embedding 50 mA 3.3 and IO-Link PHY L6364Q V and 5.0 V voltage regulators, DC-DC converter and M-sequence management. device The expansion board provides an affordable and easy-to-use solution for the Motion MEMS development of SIO and IO-Link industrial sensor applications, letting you easily and microphone evaluate the L6364Q communication features and robustness. MEMS expansion X-NUCLEO-IKS02A1 board for STM32 The X-NUCLEO-IOD02A1 communicates with the STM32 controller via SPI and Nucleo GPIO pins and it is compatible with the Arduino UNO R3 (default configuration) and ST morpho (optional, not mounted) connectors (when connected to a NUCLEO- Factory Automation Applications L073RZ or NUCLEO-G071RB development board). IO-Link modules Communication via IO-Link can be performed in either Multi-byte and Single-byte modes with SPI control of IC configuration and bidirectional sensor data transmission, or in Transparent mode with SPI control of IC configuration and UART interfacing for bidirectional sensor data transmission. DB3883 - Rev 1 - September 2020 www.st.com For further information contact your local STMicroelectronics sales office.X-NUCLEO-IOD02A1 The switches on the X-NUCLEO-IOD02A1 conveniently allow you to configure L6364Q and expansion board settings such as transmission mode and DC-DC converter enable/disable according to application requirements. You can also perform evaluation of comprehensive industrial sensor modules by connecting the X-NUCLEO-IOD02A1 to the X-NUCLEO-IKS02A1 sensor shield. DB3883 - Rev 1 page 2/6