82A4161 SPECIFICATION CONTROL DRAWING Date Revision TITLE SIX CONDUCTOR CABLE, JACKETED, GENERAL PURPOSE, FLEXIBLE, 600 VOLT 12-21-10 A This specification sheet forms a part of the latest issue of Raychem Specification 80. JACKET - RADIATION-CROSSLINKED, COMPONENT WIRES - 82A0111 MODIFIED FLEXIBLE ETFE FILAMENT BINDER AS REQUIRED CABLE CONSTRUCTION DETAILS JACKET THICKNESS OUTSIDE DIAMETER CONDUCTOR MAXIMUM PART NUMBER (in.) (in.) SIZE WEIGHT 1/ (AWG) (lbs/1000 ft.) MINIMUM NOMINAL NOMINAL MAXIMUM 82A4161-26-* 26 .006 .009 .117 .123 11.5 82A4161-24-* 24 .006 .009 .129 .135 16.1 82A4161-22-* 22 .007 .010 .149 .156 22.0 82A4161-20-* 20 .007 .011 .181 .190 31.4 82A4161-18-* 18 .009 .013 .218 .229 49.1 82A4161-16-* 16 .009 .014 .265 .278 73.1 82A4161-14-* 14 .011 .017 .331 .348 117. 82A4161-12-* 12 .013 .020 .403 .423 175. CABLE RATINGS AND ADDITIONAL REQUIREMENTS TEMPERATURE RATING: 150C SECANT MODULUS (Test per ASTM D 882): 4 2 Maximum continuous conductor temperature 4.0 x 10 lbf/in (maximum), VOLTAGE RATING: 600 volts (rms) at sea level 2% strain, 2 inch jaw separation, 0.2 inch/minute CROSSLINKING PROOF TEST: 300 3C for 7 hours DIELECTRIC WITHSTAND: 1500 volts (rms), 60 Hz PART NUMBER: JACKET COLOR: White preferred The * in the part numbers above shall be replaced by color code JACKET ELONGATION AND TENSILE STRENGTH: designators with a slash separating the component wire colors and a Elongation, 100% (minimum) dash separating the component wire colors from the jacket color. Colors Tensile Strength, 3000 lbf/in (minimum) shown do not necessarily reflect the sequence of manufacturing. 1/ Example: AWG 20, black, brown, red, orange, yellow and green NOTE: Nominal values are for information only. component wires white jacket: 82A4161-20-0/1/2/3/4/5-9 Nominal values are not requirements. Users should evaluate the suitability of this product for their application. Specifications are subject to change without notice. Tyco Electronics also reserves the right to make changes in materials or processing, which do not affect compliance with any specification, without notification to Buyer. 1/ COLORS AND COLOR CODE DESIGNATORS SHALL BE IN ACCORDANCE WITH MIL-STD-681. HOWEVER, DUE TO LENGTH LIMITATIONS OF THE RAYCHEM PART NUMBER, AN ALTERNATIVE COLOR CODE MAY REPLACE MIL-STD-681 COLOR CODE DESIGNATORS. (EXAMPLE: 901/902... MAY BE REPLACED BY Axxx.) OTHER CODES AND SUFFIXES MAY BE ADDED TO THE PART NUMBER AS NECESSARY, TO CAPTURE ANY ADDITIONAL REQUIREMENTS IMPOSED BY THE PURCHASE ORDER. The TE logo, Tyco Electronics and Raychem are trademarks. Raychem Wire & Cable 501 Oakside Avenue DIMENSIONS ARE IN INCHES, AND UNLESS OTHERWISE DESIGNATED ARE NOMINAL. Redwood City, CA 94063-3800 Page 1 of 1 Phone: 1-800-227-8816 THIS SPECIFICATION SHEET TAKES PRECEDENCE OVER DOCUMENTS REFERENCED HEREIN. Fax: 1-650-361-6297 REFERENCED DOCUMENTS SHALL BE OF THE ISSUE IN EFFECT ON DATE OF INVITATION FOR BID. 2010 Tyco Electronics Corporation. All rights reserved.X-ON Electronics Largest Supplier of Electrical and Electronic Components Click to view similar products for Multi-Conductor Cables category: Click to view products by TE Connectivity manufacturer: Other Similar products are found below : 89182-010-1000 89705-008-500 6000FE-877-1000 CS2885-000 M27500-20SP2S23 6300FE-877-U1000 6309UE-877-1000 M3905-BK005 6502FE 8771000 6541PA-008-U1000 CV6807-000 CW9530-000 CX6543-000 CXA-0066-20-4-9CS2973 CXA-0078-16-1-9CS2405 CXA- 0078-22-4-9CS2405 CXA-0078-24-4-9CS2405 CXA-0140-16-6/9-9CS2405 CY0660-000 720451-000 752687-000 768146-000 773159-000 82841-877-5000 83318E-009-500 8348-060-500 83559-002-1000 83653-002-5000 83659-002-1000 83709-002-1000 8404-060-500 8469 060100 858171-000 8628-060-500 868361-001 8730-060-1000 8737-060-U1000 8747-060-100 8747-060-1000 8769-060-1000 8775-060- 500 8780-060-1000 8782-001-U1000 88444-002-1000 9159-060-500 939870-000 9423 060U500 9444 060U1000 9497 0001000 9515-060- 1000