SPECIFICATION CONTROL DRAWING Product Revision Product Dimensions Wire and Pin Dimensions Product A L B C D Name min min max min max max B-155-1501 A 1.5 0.060 1.5 0.060 2.0 0.080 0.9 0.035 1.5 0.060 0.6 0.025 B-155-1502 A 2.3 0.090 2.3 0.090 2.9 0.115 1.1 0.045 2.3 0.090 0.9 0.035 B-155-1503 A 2.8 0.110 2.8 0.110 3.2 0.125 1.6 0.065 2.8 0.110 1.2 0.045 B-155-1504 A 3.8 0.150 3.8 0.150 4.5 0.180 1.8 0.070 3.8 0.150 1.5 0.060 MATERIALS 1. INSULATION SLEEVE: Heat-shrinkable, transparent clear, radiation cross-linked modified polyolefin. 2. SOLDER PREFORM WITH FLUX: SOLDER: TYPE Sn42Bi58 per ANSI / J-STD-006. FLUX: TYPE ROM1 per ANSI / J-STD-004. APPLICATION 1. These controlled soldering devices are designed for termination of a wire to the lead of electrical component or to the terminal of a connector. 2. Temperature range: -55C to +125C. 3. For installation procedure and application equipment, consult RPIP-824-00 For best results, prepare the wire as shown: Stripping Dimensions: 1) Wires smaller than AWG 18: E: 6.50.5 0.2560.020 F: 8.00.5 0.3150.020 2) Wires AWG 18 and larger: E: 9.50.5 0.3740.020 F: 11.00.5 0.4330.020 TITLE: TE Connectivity SOLDERSLEEVE ONE-STEP WIRE Raychem 300 Constitution Drive, TERMINATOR, LOW TEMPERATURE Menlo Park, CA. 94025, U.S.A. DOCUMENT NO.: Unless otherwise specified dimensions are in millimeters. Inches dimensions are shown in brackets B-155-150X TOLERANCES: ANGLES: N/A TE Connectivity reserves the right to amend 0.00 N/A this drawing at any time. Users should evaluate PROD. REV.: DOC. ISSUE: DATE: 0.0 N/A ROUGHNESS IN the suitability of the product for their SEE TABLE 2 16-Apr-11 0 N/A MICRON application. PREPARED BY: DCR NUMBER: REPLACES: CAGE CODE : SCALE: SIZE: SHEET: mforonda D050256 --- 06090 --- A 1 of 1 Print Date: 9-May-11 2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company. All Rights Reserved. If this document is printed it becomes uncontrolled. Check for the latest revision.