ZS Series High Impedance Active Probes 1 GHz - 4 GHz Probes Key Features High signal fidelity to 4 GHz bandwidth The ZS Series probes are high impedance, low capacitance active Low circuit loading High input impedance and low capacitance probes that maintain high signal fidelity through 4 GHz. A small form 4 GHz, 2.5 GHz, 1.5 GHz and factor and a wide variety of accessories ensures the ZS probe meets 1 GHz models every difficult probing challenge. 1 M input resistance High Impedance Reduces A Variety of Probe Tips for 0.6 pF (4 GHz) and 0.9 pF input Circuit Loading across Full Varied Tasks capacitance Oscilloscope Bandwidth The small form factor and extensive 8 V input dynamic range, Engineers must commonly probe range of standard probe tips ensures 12 V offset range high frequency signals with high that this probe can meet any difficult Wide variety of tips and grounds signal fidelity. Typical passive probes probing challenge. Various flexible with high input R and C provide good Easy to use, integrated with leads and clips, such as right-angle oscilloscope response at lower frequencies but leads, Y-adapters, and micro-grabbers, inappropriately load the circuit and are also available for probing test distort signals at higher frequencies. points that are spaced farther apart. The ZS Series features both high Innovative Grounding Provides input R (1 M) and low input C (0.6 pF the Highest Signal Fidelity and 0.9 pF) to reduce circuit Loading Keeping the ground loop short is across the entire probe/oscilloscope critical to eliminating the effect of bandwidth. The ZS1000 is ideal high inductance on the signal. The for 200600 MHz oscilloscopes. ZS probes provide a wide variety of The ZS1500 is ideal for 1 GHz unique and innovative accessories oscilloscopes, the ZS2500 is ideal which maintain the highest signal for 2 GHz oscilloscopes, and the fidelity. They eliminate the effects of ZS4000 is ideal for 2.5 GHz and the loop on the circuit. 4 GHz oscilloscopes.EXTENSIVE SET OF PROBE TIPS AND GROUND LEADS ZS PROBE ACCESSORIES Use the Solder-In Ground with Straight Tip for general The Straight Tip and Offset Ground Lead can be used purpose browsing. together for probing signal and ground points extremely close together. Hard-to-reach spaces can be be probed with the Bent Sharp Probe directly on surface mount components, like resistors Tip and can be used with a range of ground leads like the or capacitors, with the Discrete SMD Tip. Use this tip with any flexible Short Right-Angle Lead shown here. of the ground leads, like the flexible Long Right-Angle Lead shown here. The 2.54 mm probe adapter provides full BW probing and holds The Ground Blade and Copper Pad provide the shortest the probe in place. ground loop for excellent signal fidelity when probing an IC. Use them with the insulated IC Lead Tip to prevent shorting between test points. 2