C63-10 Series 1.0A, 60 Vdc Optically Isolated Short-Circuit Protected Part Number Description C63-10 1A, 60 Vdc short-circuit protected solid-state relay for through-hole mounting SC63-10 1A, 60 Vdc short-circuit protected solid-state relay for surface mount ELECTRICAL SPECIFICATIONS FEATURES/BENEFITS (40C to +85C ambient temperature unless otherwise specied) Short-circuit protected: Prevents damage to system components, assemblies and system wiring INPUT (CONTROL) SPECIFICATIONS Optical isolation: Isolates control circuits from Min Max Units load transients and eliminates ground loops and Input Current 8 20 mA signal ground noise Input Voltage 10 mA 2 3 Vdc Low off-state leakage Must Turn-On 8 mA Switches high currents: To 1.0 Amp Must Turn-Off Current 100 A High noise immunity: Control signals isolated Must Turn-Off Voltage 0.8 Vdc from switching noise Reverse Polarity 6 Vdc High dielectric strength: For safety and for protection of control and signal level circuits OUTPUT (LOAD) SPECIFICATIONS DESCRIPTION Min Max Units The C63-10 solid-state relay utilizes a power FET Load Voltage Range 0 60 Vdc switch that is protected against short circuits and Output Current Rating (See Figure 4) 1.0 A overload currents. The short-circuit protection feature Leakage Current at Rated Voltage 10 A provides protection when a short or overload occurs Transient Blocking Voltage 25C 100 Vdc while the relay is on as well as when the relay is Output Capacitance 25Vdc (25C) 600 pF switched into an overload. In either case, the relay Output Voltage Drop 1A 0.55 Vdc will sense the overload condition and then block it On Resistance 0.55 Ohm indenitely until the overload is removed and the unit is reset by cycling the input control. Using the C63-10 to Turn-On Time 2.0 ms switch power sources and loads prevents damage to Turn-Off Time 1.0 ms system assemblies and system wiring. The power FET Trip Overload (See Figure 7) A output offers low ON resistance and can switch loads in either the high or the low side of the power line. The C63-10 is packaged in a 6-pin DIP package. 2004 TELEDYNE RELAYS (800) 284-7007 www.teledynerelays.com C63 Page 1 2DSC63-10 Rev --C63-10 Series GENERAL SPECIFICATIONS MECHANICAL SPECIFICATION (+25C ambient temperature unless otherwise specied) ENVIRONMENTAL SPECIFICATION Min Max Units Operating Temperature 40 +85 C Storage Temperature 40 +100 C Junction Temperature 1A +125 C Thermal Resistance 125 C/W JA Dielectric Strength 1000 Vac Insulation Resistance 9 ( 500 Vdc) 10 Ohm Input to Output Capacitance 5 pF Resistance to Soldering Heat MIL STD 202, method 210 Solderability MIL STD 202, method 208 Thermal Shock MIL STD 202, method 107 Figure 1 TYPICAL WIRING DIAGRAM Rs 1 6 ** LOAD 2 5 * 3 4 LOAD * *Shorted internally **Series resistor required to limit input current to 20mA maximum Figure 2 FUNCTIONAL BLOCK DIAGRAM +IN (1) +OUT (6) Output Switch INPUT Optical Detection Switching (MOSFET) with Isolation Circuit Circuit with Current LEDs Sense OUT (4) IN (3) Figure 3 C63 Page 2 SPECIFICATIONS ARE UNDER REVISION CONTROL 2004 TELEDYNE RELAYS 2DSC63-10 Rev -- C63
