TC75S70L6X CMOS Linear Integrated Circuits Silicon Monolithic TC75S70L6X 1. Functional Description Single Comparator 2. General This is a CMOS Input/Output full swing comparator with low operating voltage and low supply current. The comparator have low operating voltage V = 1.3 V to 5.5 V and low supply current I = 18 A (typ.) V DD DD DD = 1.5 V. Output circuit type is push-pull circuit. The package MP6C (1.0 mm 1.45 mm, t: 0.55 mmMAX) is ultra small, so that it is ideal for high-density assembly such as cellular phone. 3. Features (1) Single circuit, Input/Output full swing comparator (2) Low operating voltage: V = 1.3 V to 5.5 V DD (3) Low supply current: I = 18 A (typ.) ( V = 1.5 V) DD DD (4) Ultra Small package: MP6C (1.0 mm 1.45 mm, t = 0.55 mmMAX) (5) Low input bias current: 1 pA (typ.) (6) Push-pull output circuit (7) Single power supply operation 4. Packaging and Pin Assignment MP6C Start of commercial production 2013-12 2020 2020-11-26 1 Toshiba Electronic Devices & Storage Corporation Rev.3.0TC75S70L6X 5. Absolute Maximum Ratings (Note) (Unless otherwise specified, T = 25 ) a Characteristics Symbol Note Rating Unit Supply voltage V 3.0 or 6.0 V DD Differential input voltage V 6.0 V IN Input voltage V V to V V IN SS DD Output current I 35 mA OUT Power dissipation P (Note 1) 250 mW D Operating temperature T -40 to 85 opr Storage temperature T -55 to 125 stg Junction temperature T 125 j Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings. Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook Handling PrecautionDerating Concept and Method) and individual reliability data (i.e. reliability test report and estimated failure rate, etc). Note: Since this device is susceptible to latch-up, a phenomenon inherent to CMOS devices, follow these considerations: - Don t raise the voltage level of the output pins above V or lower it below V . DD SS Consider the power-on timing as well. - Ensure that any abnormal noise is not introduced into the device. Note 1: Mounted on an FR4 board. 6. Operating Ratings (Unless otherwise specified, T = 25 ) a Characteristics Symbol Rating Unit Supply voltage V 1.3 to 5.5 V DD Supply voltage V ,V 0.65 to 2.75 V DD SS 7. Thermal Characteristics Characteristics Symbol Rating Unit Thermal resistance (junction-to-ambient) (Note 1) R 400 /W th(j-a) Note 1: Mounted on an FR4 board. 2020 2020-11-26 2 Toshiba Electronic Devices & Storage Corporation Rev.3.0