TLP2710(TP4,E Toshiba

TLP2710 Photocouplers GaAAs Infrared LED & Photo IC TLP2710TLP2710TLP2710TLP2710 1. 1. ApplicationsApplications 1. 1. ApplicationsApplications Programmable Logic Controllers (PLCs) Battery Management System (BMS) Industrial Inverters 2. 2. 2. 2. GeneralGeneralGeneralGeneral The TLP2710 is a 5-Mbps low-power photocoupler in the small SO6L package. It is housed in a thin SO6L package of 2.3 mm (max). The TLP2710 has guaranteed the isolation voltage 5 kVrms and compliant with international safety standards for reinforced insulation. The TLP2710 consumes supply current (I /I ) of only 0.3 mA DDL DDH maximum over the entire operating temperature range of -40 to 125 and operates at a supply voltage as low as 2.7 V, contributing to a reduction in power consumption of various systems. The input forward current can be less than 1 mA maximum, allowing direct drive by a microcontroller. The detector has a totem-pole output stage with current sourcing and sinking capabilities. The TLP2710 has an internal Faraday shield that provides a guaranteed common-mode transient immunity of 25 kV/s. 3. 3. FeaturesFeatures 3. 3. FeaturesFeatures (1) Package: SO6L (2) Data transfer rate: 5 MBd (typ.) (NRZ) (3) Supply current: 0.3 mA (max) (4) Threshold input current: 1.0 mA (max) (5) Supply voltage: 2.7 V to 5.5 V (6) Operating temperature: -40 to 125 (7) Propagation delay time: 250 ns (max) (8) Pulse width distortion: 30 ns (max) (9) Isolation voltage: 5000 Vrms (min) (10) Safety standards UL-approved: UL1577, File No.E67349 cUL-approved: CSA Component Acceptance Service No.5A File No.E67349 (Note 1) VDE-approved: EN60747-5-5, EN60065, EN60950-1, EN 62368-1 (Note 1)(Note 1)(Note 1) Option (D4) Note 1: When a VDE approved type is needed, please designate the Option (D4)Option (D4)Option (D4). Start of commercial production 2015-05 2015-2018 2018-03-09 1 Toshiba Electronic Devices & Storage Corporation Rev.6.0TLP2710 4. 4. 4. 4. Packaging (Note)Packaging (Note)Packaging (Note)Packaging (Note) TLP2710 TLP2710(LF4) 11-4N1A 11-4N101A Note: Lead-formed product: (LF4) 5. Pin Assignment 5. 5. 5. Pin AssignmentPin AssignmentPin Assignment 1: Anode 2: N.C. 3: Cathode 4: GND 5: V (Output) O 6: V DD 6. 6. 6. 6. Internal Circuit (Note)Internal Circuit (Note)Internal Circuit (Note)Internal Circuit (Note) Note: A 0.1-F bypass capacitor must be connected between pin 6 and pin 4. 2015-2018 2018-03-09 2 Toshiba Electronic Devices & Storage Corporation Rev.6.0