TS14001 Version 1.5 nanoSmart Ultra-Low-Power Linear Regulator DESCRIPTIONS FEATURES The TS14001 linear regulator is an ultra-low- Ultra-low nA operating current at light load power circuit which draws low nA level Best-in-class quiescent current of 20nA at quiescent current at light load, but has the I =0 load capability to regulate current loads as high as Best-in-class quiescent current of 100pA in 200mA. disable mode Output voltage options of 1.2V - 4.2V in 100mV steps (programmed at APPLICATIONS manufacturing) Portable electronics Accurate output regulation Over-current protection RFID Industrial Medical SUMMARY SPECIFICATIONS Energy harvesting systems Low input operating voltage of 2.5V to 5.5V SmartCard Packaged in a 8pin VDFN (2x2) Block Diagram VCC VOUT Current Limit FB Reference Voltage EN GND Specifications subject to change WWW.TRIUNESYSTEMS.COM Copyright 2012, Triune Systems, LLC - 1 - TS14001 Version 1.5 TYPICAL APPLICATION TS14001 VOUT VCC Load C C BYP OUT EN FB GND PIN-OUT CONFIGURATION PIN NAME I/O/P DESCRIPTION 1 GND P Ground 2 V O Regulated Output Voltage OUT 3 NC No Connect (connect to GND or float) 4 NC No Connect (connect to GND or float) 5 NC No Connect (connect to GND or float) 6 FB I Feedback Input 7 V P Input Power CC 8 EN I Enable Input ABSOLUTE MAXIMUM RATINGS (1,2,3) Over operating free air temperature range unless otherwise noted PIN / PARAMETER VALUE UNIT V , V , EN, FB -0.3 to 6.0 V CC OUT Electrostatic Discharge (Human Body Model) 2 kV Operating Junction Temperature Range, T -20 to 85 C J Storage Temperature Range, T -65 to 150 C STG Lead Temperature (soldering, 10 seconds) 260 C Note 1: Stresses beyond those listed under absolute maximum ratings may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated under recommended operating conditions is not implied. Exposure to absolutemaximumrated conditions for extended periods may affect device reliability. Note 2: All voltage values are with respect to network ground terminal. Note 3: ESD testing is performed according to the respective JESD22 JEDEC standard. Specifications subject to change WWW.TRIUNESYSTEMS.COM Copyright 2012, Triune Systems, LLC - 2 -