DS1088L Fixed-Frequency EconOscillator General Description Features The DS1088L is a low-cost clock generator that pro- Factory-Programmed Square-Wave Generator from duces a square-wave output without external timing 321kHz to 133MHz components. The fixed-frequency oscillator is available in Single Output factory-calibrated frequencies from 312kHz to 133MHz. No External Timing Components Required The device has a power-down pin for power-sensitive 2.7V to 3.6V Supply applications. Power-Down Mode Applications 1% Frequency Tolerance Over Temperature and Printers Voltage Copiers Wide Temperature Range (-20C to +85C) Computer Peripherals POS Terminals Cable Modems Typical Operating Circuit 312kHz TO 133MHz Ordering Information appears at end of data sheet. OUTPUT OUT DNC DS1088L V DNC CC V V CC CC V PDN CC GND GND DECOUPLING CAPACITORS (0.1F AND 0.01F) EconOscillator is a trademark of Maxim Integrated Products, Inc. For related parts and recommended products to use with this part, refer to www.maximintegrated.com/DS1088L.related. 19-6184 Rev 3 4/15DS1088L Fixed-Frequency EconOscillator Absolute Maximum Ratings (Voltages relative to ground.) Storage Temperature Range ............................ -55C to +125C Voltage Range on V .........................................-0.5V to +6.0V Lead Temperature (soldering, 10s) .................................+300C CC Voltage Range on PDN ...........................-0.5V to (V + 0.5V)* Soldering Temperature (reflow) .......................................+260C CC Operating Temperature Range ........................... -20C to +85C *Not to exceed +6.0V. Stresses beyond those listed under Absolute Maximum Ratings may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability. Recommended Operating Conditions (T = -20C to +85C, unless otherwise noted.) A PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS Supply Voltage V (Note 1) 2.7 3.6 V CC V 0.7 x V V + 0.3 V High-Level Input Voltage (PDN) IH CC CC V -0.3 0.3 x V V Low-Level Input Voltage (PDN) IL CC DC Electrical Characteristics (V = 2.7V to 3.6V, T = -20C to +85C, unless otherwise noted.) CC A PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS High-Level Output Voltage (OUT) V I = -4mA, V = MIN V - 0.4 V OH OH CC CC Low-Level Output Voltage (OUT) V I = 4mA 0.4 V OL OL I V = 3.6V 1 A High-Level Input Current (PDN) IH CC I V = 0V -1 A Low-Level Input Current (PDN) IL IL Supply Current (Active) I V = 3.6V, C = 15pF, f = 133MHz 15 24 mA CC CC L O Standby Current (Power-Down) I Power-down mode 10 A CCQ Maxim Integrated 2 www.maximintegrated.com