POWER LCM600 Data Sheet 600 Watt Bulk Front End Total Power: 600 W of Outputs: Single Outputs: 12 to 60 V Optional 5.0 V standby SPECIAL FEATURES 600 W output power Low cost 2.4 x 4.5 x 7.5 7.41 W/cu-in Electrical Specifications Industrial/Medical safety Input -40 C to 70 C with derating Input ra nge 85 - 264 Vac (Operating) Optional 5 V 2 A housekeeping 115/230 Vac (Nominal) Input through standard IEC connector/ TERMINAL BLOCK High efficiency: 89% typical Frequency 47 - 440 Hz, Nominal 50/60 Variable speed Smart Fans DSP controlled front end Input fusing Internal 10 A fuses, both lines fused Conformal coat option Inrush current 25 A peak, either hot or cold start 20% adjustment range Power factor 0.99 typical, meets EN61000-3-2 Margin programming Harmonics Meets IEC 1000-3-2 requirements OR-ing FET Input current 8 A RMS max input current, at 100 Vac Terminal block input option Hold up time 20 ms minimum for main O/P, at full rated load Efficiency > 89% at full load COMPLIANCE Leakage current < 300 A 240 Vac EMI Class B ON/OFF power switch N/A EN61000 Immunity Power line transient MOV directly after the fuse Isolation Isolation: PRI-Chassis 2500 Vdc Basic SAFETY PRI-SEC 4000 Vac Reinforced 2xMOPP UL/CSA UL60950-1/CSA C22.2 SEC-Chassis 500 Vdc No. 60950-1 ES60601-1/CSA C22.2 LCM600Q Ef ciency Without the 5 Vsb No. 60601-1 92.00 TUV EN60950-1 90.00 EN60601-1 88.00 CB Report IEC60950-1 86.00 IEC60601-1 100 Vac 84.00 CCC GB4943, GB9254 230 Vac and GB17625 82.00 80.00 78.00 76.00 25 50 75 100 Loading % Ef ciency %LCM600 Data Sheet Electrical Specifications Output Output rating See ordering information table 85 - 264 Vac Set point 0.5% 85 - 264 Vac Total regulation range Main output 2% Combined line/load/transient when measured at output 5 Vsb 1% terminal Rated load 600 W maximum Derate linear to 50% from 50 C to 70 C Minimum load Main output 0.0 A No loss of regulation 5 Vsb 0.0 A Output noise (PARD) 1% max p-p Main output 50 mV max p-p 5 Vsb output Measured with a 0.1 F Ceramic and 10 F Tantalum Capacitor on any output, 20 MHz Output voltage overshoot No overshoot/undershoot outside the regulation band during on or off cycle Transient response < 300 Sec 50% load step 1 A/s Step load valid between 10% to 100% of output rating Recovery time to within 1% of set point at onset of transient Max units in parallel Up to 10 Short circuit protection Protected, no damage to occur Bounce mode Remote sense Compensation up to 500 mV Output isolation Standard per safety requirements Forced load sharing To within 10% of all shared outputs Analog sharing control Overload protection (OCP) 105% to 125% Main output 120% to 170% 5 Vsb output Overvoltage protection (OVP) 125% to 145% 12 V output 110% to 125% 5 Vsb output Overtemp protection 10 - 15 C above safe operating area Both PFC and output converter monitored Fan Fault Protection For-N option only. Will shutdown output and DC OK Environmental Specifications Operating temperature -40 C to +70 C, linear derating to 50% from 50 C to 70 C Storage temperature -40 C to +85 C Humidity 10 to 90%, non-condensing. Operating. Conformal coat option available. Fan noise < 45 dBA, 80% load at 30 C -N Low Noise Option < 35 dBA, 80% Load at 30 C Altitude Operating - 16,404.2 feet Storage - 30,000 feet Shock MIL-STD-810F 516.5, Procedure I, VI. Storage Vibration MIL-STD-810F 514.5, Cat. 4, 10. Storage Ordering Information Current Model Nominal Output Set Point Output Ripple Max Continuous Combined Line/ Number* Output Voltage Set Point Tolerance Adjustment Range Min Max P/P (0-50 C) Power Load Regulation LCM600L 12 V 12 V 0.5% 9.6 - 14.4 V 0 A 52 A 120 mV 600 W 2% LCM600N 15 V 15 V 0.5% 12.0 - 19.5 V 0 A 44 A 150 mV 600 W 2% LCM600Q 24 V 24 V 0.5% 19.2 - 28.8 V 0 A 27 A 240 mV 600 W 2% LCM600U 36 V 36 V 0.5% 28.8 - 43.2 V 0 A 16.7 A 240 mV 600 W 2% LCM600W 48 V 48 V 0.5% 38.4 - 57.6 V 0 A 14 A 280 mV 600 W 2% *Note: Add -T for terminal block instead of IEC input Add -N for low noise model on 12 V or 24 V models Add -4 for 5 V Standby output Add -A will be automatically added to all orders to denote new Aesthetics style chassis unless otherwise specified Add -8 for models with special Constant Current Mode operation Example: a 24 V with terminal block, low noise and standby with new Aesthetics would be LCM600Q-T-N-4-A