Embedded Power for Business-Critical Continuity Rev. 09.15.09 12 LPS120 Series 1 of 3 LPS120 Series 120 Watts Total Power: 80 - 130 Watts Input Voltage: 85 - 264 VAC of Outputs: Single Electrical Specifications Special Features Input Active power factor correction Input range: 85 - 264 VAC 127 - 300VDC 3 x 5 footprint Frequency: 47 - 440 Hz Less than 1U high Inrush current: 40 A max., cold start 25 C EN61000-3-2 compliant Efficiency: 80% typical at full load Remote sense EMI/RFI: Power fail and remote inhibit FCC Class B conducted CISPR22 Class B conducted EN55022 Class B con- Single wire current sharing ducted VDE0878PT3 Class B conducted Adjustable main output Power factor: 0.99 typical Built-in Class B EMI filter 0.5 mA 50/60 Hz, 264 VAC input Safety ground Overvoltage protection leakage current: Overload protection Output Thermal overload protection Maximum power: 80 W for convection 130 W with 30CFM forced air 5 V Standby output and 12V Fan output Adjustment range: 5% minimum on the main outputs Fan output: 12 V 500mA - 5%, +7% Standby outputs: 5V 500mA 5% Hold-up time: 20ms 125 W load, 120 VAC input Overload protection: Short circuit protection on all outputs. Case overload protected 120 - 135% above rating Overvoltage protection: 20 - 35% above nominal output Remote sense: Compensates for 0.5 V lead drop max. Will operate without remote sense connected. Reverse connection protected. Logical Control Power failure: TTL logic signal goes high 100 - 500 msec after main output it goes low at Safety least 4 msec before loss of regulation TUV: 60950 Remote inhibit: Requires a contact closure to disable the outputs, except 5 V standby. UL: 60950 Remote sense: Compensates for 0.5 V lead drop min. Will operate without remote sense CSA 60950 connected. Reverse connection protected. NEMKO: 60950 AUSTEL: 60950 CB: Certificate and report CE: Mark (LVD)1 SK2 2 NEUTRAL SK1 LIVE SK3 P1 EARTH Embedded Power for Business-Critical Continuity Rev. 09.15.09 128 LPS120 Series Environmental Specifications 2 of 3 Operating temperature: 0 to 50 C ambient derate each Mechanical Drawing output as 2.5% per degree from 3.00 50 to 70 C. -20 C start up (76.2) Storage temperature: -40 C to +85 C 2.55 Electromagnetic Designed to meet EN61000-4 (64.8) susceptibility: -2, -3, -4, -5, -6, -8, -11 Level 3 0.15 DIA. 4 places (4.0) Operating non-condensing Humidity: 10% to 95% RH IEC68-2-6 to the levels of Vibration: IEC721-3-2 > 550,000 hours at full load and MTBF demonstrated 25 C ambient conditions 5.00 (127.0) 4.55 (115.6) V Adjust M3.5 (2 places) POT 1.29 (32.8) 1 5 6 10 SK3 0.20 (5)