FDB-1043 Finisar

Product Specification CXP Evaluation Board FDB-1043 INTRODUCTION: Finisars FDB-1043 CXP Evaluation Board is designed for testing and evaluating the CXP transceiver and CXP Active optical cables. It is compatible with all MSA compliant CXP transceivers. The board consists of a single 84 pin CXP edge connector and CXP cage assembly. There are forty-eight 50-ohm SMP coaxial connectors (J6 J53), for the high-speed differential transmitter input, and receiver output signals, and test points with LEDs for monitoring the following CXP and Evaluation Board pins: MOD STAT (Module Status) MOD PWR (Module Power) EXTPWR (External Power Supply) PRSL (Module Present) INTL (Module Interrupt L and Reset L) 3.3 V (Module Power Supply) The I2C pins (SDA, SCL and GND) have tap points available on top of the Evaluation Board. There are also tap points for PRSL and INTL. The Evaluation Board has LEDs to indicate that the USB port is active. There is provision for a mini-USB port (J4), so if additional functionality is needed, module functionality can be read over the I2C, using the USB interface. A Customer Friendly GUI is available and can be requested. Finisar Corporation Document FDB-1043 Rev B Page 1 of 4 July 2010 FDB-1043 F i n i s a r SPECIFICATIONS The FDB-1043 CXP Evaluation Board is powered by a supply voltage of +6V, at 1.75 A from the 100V-240V AC, 50-60 Hz adaptor (this is included with the purchase of the board). External power +6V to board +3.3V to module USB Interface Low Speed Interface Jumpers and LEDs Local Control and Status LEDs Rx High Speed Interface - 12 pairs Tx High Speed Interface - 12 pairs Fan CXP Cage CUSTOMER GUI A customer GUI is available upon request that can be used in conjunction with the FDB- 1043 Evaluation Board. The GUI functionality is based on the CXP MSA, and is outlined in AN-2077, & AN-2073. Please refer to these Application Notes, for additional details. INSTALLATION OF THE CUSTOMER GUI To install the GUI, please follow the instructions below: 1) Ensure Microsoft.NET Framework 2.0 or greater is installed. Check in C: WINDOWS Microsoft.NET Framework. If it is not already installed, rundotnetfx.ex. 2) Unzip the Finisar CXP Demo.zip file 3) Copy theCXPDem folder into Program Files, or any appropriate location. 4) In the USB DLL Stuff folder, run the batch file FNSREvalUSB.bat 4) Plug the CXP demo in with DC power and the USB cable to the computer 5) WAIT until the PC recognizes the USB device 6) Run the main programCXPdemo 091014.ex Finisar Corporation Document FDB-1043 Rev B Page 2 of 4