HFE4082-321 Finisar

F i n i s a r Product Specification 1.25Gbps VCSEL Component, TO-46 HFE4082-321 PRODUCT FEATURES Designed for drive currents between 5 and 15 mA Optimized for low dependence of electrical properties over temperature High speed >1 GHz Two different laser/photodiode polarities Attenuating coating Packaged with a photo-detector The HFE4082-321 is a high-performance 850 nm VCSEL (Vertical Cavity Surface- Emitting Laser) packaged for high-speed data communications. This product combines all the performance advantages of the VCSEL with a custom designed power monitor diode. The power monitor diode can be used with appropriate feedback control circuitry to set a maximum power level for each VCSEL. In addition, built-in power attenuation reduces the effective slope efficiency. These combined features simplify design for high data rate communication and eye safety. The HFE4082-321 is a high radiance VCSEL, designed to convert electrical current into optical power that can be used in fiber optic communications and other applications. As the current increases above threshold, the light intensity increases proportionally. The HFE4082-321 is designed to be used with inexpensive silicon or gallium arsenide detectors (see HFD3081-108), but excellent performance can also be achieved with some indium gallium arsenide detectors. The low drive current requirement makes direct drive from PECL (Positive Emitter Coupled Logic) or EML (Emitter Coupled Logic) gates possible and eases driver design. The HFE4082-321 is designed to interface with 50/125 and 62.5/125 um multimode fiber. They produce circularly symmetric, non-astigmatic, narrow divergence beams that, with appropriate lensing, fiber couple all of the emitter power. PRODUCT SELECTION Part Number Description HFE4082-321 Attenuated VCSEL with Back Monitor Photodiode - VCSEL Anode Common Confidential and Proprietary 2012 Finisar Corporation. All rights reserved Rev. A1 Page 1 HFE4082-321 Product Specification April 2013 F i n i s a r I. Absolute Maximum Ratings Parameter Rating Storage Temperature -40 to +85C Case Operating Temperature 0 to +70C Lead Solder Temperature 260C, 10 sec. Laser continuous average current 15mA Laser peak forward current with pulse 20mA width less than 1us Laser reverse voltage 5V 1 ESD Exposure (Human Body Model) 225V 1 Heel and wrist straps must be used on a properly grounded workstation Notice Stresses greater than those listed under Absolute Maximum Ratings may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operations section for extended periods of time may affect reliability. Notice The inherent design of this component causes it to be sensitive to electrostatic discharge (ESD). To prevent ESD-induced damage and/or degradation to equipment, take normal ESD precautions when handling this product Confidential and Proprietary 2012 Finisar Corporation. All rights reserved Rev. A1 Page 2