HFE4094-542 Finisar

F i n i s a r Product Specification 2.5Gbps, 850nm VCSEL, TO-46 Package HFE4094-542 PRODUCT FEATURES 850nm multi-mode oxide isolated VCSEL Capable of modulation operation from DC to 2.5Gbps TO-46 tilt window metal can component Designed for drive currents between 3- 15mA average Packaged with a back monitor Un-Attenuated window can These products are high-performance 850nm VCSELs (Vertical Cavity Surface-Emitting Lasers) designed for high-speed data communications and packaged with a custom designed power monitor diode. The power monitor diode can be used with appropriate feedback control circuitry to set a maximum power level for the VCSEL. These combined features simplify design for high data rate communication and eye safety. These products are high radiance VCSELs designed to convert electrical current into optical power that can be used in fiber optic communications and other applications. As the current varies above threshold, the light intensity increases proportionally. These products are designed to be used with inexpensive silicon or gallium arsenide detectors, but excellent performance can also be achieved with some indium gallium arsenide detectors (see HFD3081-108 and HFD3081-203 product data sheets). The low drive current requirement makes direct drive from PECL (Positive Emitter Coupled Logic) or ECL (Emitter Coupled Logic) gates possible and eases driver design. These are designed to interface with 50/125 and 62.5/125mm multi-mode fiber. They produce circularly symmetric, non-astigmatic, narrow divergence beams that, with appropriate lensing, fiber couple all of the emitter power PRODUCT SELECTION Part Number Description Un-Attenuated TO-46 component, VCSEL with Back Monitor HFE4094-542 Photodiode, Cathode of VCSEL common with Photodiode Anode Confidential and Proprietary 2013 Finisar Corporation. All rights reserved Rev. A1 Page 1 HFE4094-542 Product Specification Aug 2014 F i n i s a r I. Absolute Maximum Ratings Parameter Rating Storage Temperature -40 to +100C Case Operating Temperature -40* to +85C Lead Solder Temperature 260C, 10 sec. Laser continuous Forward Current 12mA Laser peak forward current with pulse 18mA width less than 1ms Laser Reverse voltage 5V 1 ESD Exposure (Human Body Model) 225V Notice Stresses greater than those listed under Absolute Maximum Ratings may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operations section for extended periods of time may affect reliability. Notice The inherent design of this component causes it to be sensitive to electrostatic discharge (ESD). To prevent ESD-induced damage and/or degradation to equipment, take normal ESD precautions when handling this product Confidential and Proprietary 2013 Finisar Corporation. All rights reserved Rev. A1 Page 2