BTT62004ESAXUMA1 Infineon

RLED RPD R R RPD ROL PD PD RGND RIS PROFET + 24V BTT6200-4ESA Feature list Quad channel device Very low stand-by current 3.3 V and 5 V compatible logic inputs Electrostatic discharge protection (ESD) Optimized electromagnetic compatibility Logic ground independent from load ground Very low power DMOS leakage current in OFF state Green product (RoHS compliant) Potential applications Suitable for resistive, inductive and capacitive loads Replaces electromechanical relays, fuses and discrete circuits Most suitable for loads with high inrush current, such as lamps Suitable for 12 V and 24 V trucks and transportation systems VBAT Voltage Regulator OUT VS GND T1 Z CVDD CVS V VS DD I/O RDEN DEN OUT0 COUT Relay I/O RDSEL DSEL0 86 30 OUT1 I/O RDSEL DSEL1 COUT 85 87 I/O RIN IN0 Micro controller + RIN OUT2 I/O IN1 COUT E.C.U. OUT3 - RIN I/O IN2 R I/O IN IN3 OUT3 OUT4 COUT R A/D SENSE IS GND LED R5W GND CSENSE D Page-1 Figure 1 Application Diagram with BTT6200-4ESA Product Type Package Marking BTT6200-4ESA PG-TSDSO-24 BTT62004ESA Datasheet Please read the Important Notice and Warnings at the end of this document Rev. 1.00 www.infineon.com 2019-03-09 PROFET + 24V BTT6200-4ESA Product summary Product summary The BTT6200-4ESA is a 200 m quad channel Smart High-Side Power Switch, embedded in a PG-TSDSO-24 package, providing protective functions and diagnosis. The power transistor is built by an N-channel vertical power MOSFET with charge pump. The device is integrated in Smart6 HV technology. It is specially designed to drive lamps up to R10 W 24 V or R5 W 12 V, as well as LEDs in the harsh automotive environment. Table 1 Product summary Parameter Symbol Value Operating voltage range V 5 V to 36 V S(OP) Maximum supply voltage V 65 V S(LD) Maximum ON state resistance at T = 150C per channel R 400 m J DS(ON) Nominal load current (one channel active) I 1.5 A L(NOM)1 Nominal load current (all channels active) I 1 A L(NOM)2 Typical current sense ratio k 300 ILIS Minimum current limitation I 9 A L5(SC) Maximum standby current with load at T = 25C I 500 nA J S(OFF) Diagnostic functions Proportional load current sense multiplexed for the 4 channels Open load detection in ON and OFF Short circuit to battery and ground indication Overtemperature switch off detection Stable diagnostic signal during short circuit Enhanced k dependency with temperature and load current ILIS Protection functions Stable behavior during undervoltage Reverse polarity protection with external components Secure load turn-off during logic ground disconnection with external components Overtemperature protection with latch Overvoltage protection with external components Enhanced short circuit operation Product validation Qualified for Automotive Applications. Product validation according to AEC-Q100/101. Datasheet 2 Rev. 1.00 2019-03-09