CY8CKIT-143 Infineon

CY8CKIT-143 PSOC 4 BLE 256K MODULE CY8CKIT-143 PSoC 4 BLE 256K Module is an easy-to-use solution for creating a complete BLE system. It features a PSoC 4 BLE device with 256 KB internal ash, 24-MHz and 32.768-kHz crystals, a PCB antenna, and other passives while providing access to all GPIOs of the device. For more information on Cypresss BLE solutions visit www.cypress.com/BLE PSoC 4 BLE is an ARM Cortex -M0 based single-chip solution that integrates a programmable analog front end, programmable digital peripherals, CapSense touch-sensing technology, and a Bluetooth Low Energy or Bluetooth Smart radio. Antenna matching Wiggle antenna network (AMN) Ctank 24-MHz crystal Cmod P0 1 P0 0 GND VDDA P0 3 P0 2 P3 6 P3 7 P0 5 P0 4 P3 4 P3 5 P1 0 VREF P3 2 P3 3 P1 2 P1 1 P3 0 P3 1 P0 6 P1 4 P4 0 P5 1 P0 7 P1 3 P4 1 P5 0 XRES P1 5 P2 6 P2 7 GND P1 7 P2 4 P2 5 VDDD P1 6 P2 2 P2 3 P2 0 P2 1 SAR bypass capacitor VDDR GND (bottom side) 32.768-kHz crystal (bottom side) CY8C4248LQI-BL483 PSoC 4 BLE device 4-pin UART header Fig-1: Pinout Description for PSoC 4 BLE Module Note: To apply power to the module, use the VDD pin (1.9 V - 5.0 V) and GND pin. VDD GND P1 5 P1 4 CY8CKIT-143 PSOC 4 BLE 256K MODULE TM STANDALONE USE WITH PSOC CREATOR IDE AND CY8CKIT-002 MINIPROG3 Step 1: Select the 5-pin connector setting in PSoC Creator or PSoC Programmer. Step 2: Use 0.1 male headers (not included) or jumper wires to connect the MiniProg3 to the module. Pin Mapping CY8CKIT-002 CY8CKIT-143 VTARG VDD GND GND RES XRES SCLK P0 7 SDAT P0 6 Fig-2: Programming and Debugging with CY8CKIT-002 MiniProg3 USING THE CY8CKIT-143 MODULE WITH CY8CKIT-042-BLE PIONEER KIT Step 1: Plug the module on the CY8CKIT-042-BLE Pioneer Kit Baseboard. Step 2: Create your design in PSoC Creator IDE and use the BLE Pioneer Kit to program and debug. Fig-3: Programming and Debugging with CY8CKIT-042-BLE Pioneer Baseboard The CY8CKIT-143 module is intended to be used for evaluation of hardware and software in a laboratory environment. This module radiates radio frequency energy and has not been tested for compliance with limits applicable under any standard. Operation of this module may cause interference with radio communications. Cypress recommends that the module should only be used in a shielded room. Contact support cypress.com for details. For more information about this kit, visit www.cypress.com/CY8CKIT-143 2015 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of their respective owners. 001-97333 Rev.**