CYBLE-013025-EVAL Infineon

TM EZ BLE MODULE ARDUINO EVALUATION BOARD CYBLE 013025 EVAL The EZ-BLE Module Arduino Evaluation Board (CYBLE-013025-EVAL) enables you to evaluate and develop applications on the CYBLE- 0130XX-00 WICED Modules (CYBLE-013025-00 and CYBLE-013030-00). CYBLE-013025-EVAL can be used as a standalone evaluation kit or can be combined with Arduino compatible shields. The CYBLE-0130XX-00 WICED Modules are fully integrated, fully certi ed,14.5 mm x 19.2 mm x 2.25 mm, programmable, Bluetooth Smart modules designed to reduce your time-to-market. For more information, visit: www.cypress.com/EZ-BLEModule - EZ-BLE Module home pages www.cypress.com/EZ-Serial - EZ-Serial BLE Firmware Platform page www.cypress.com/WICED - WICED Platform page Supply Option (J8) USB Connector Reset Switch (SW2) Recover Switch (SW4) VDD Jumper (J1) Operation Mode Switch (SW1) User De ned Switch (SW3) P24-SW3 Jumper (J9) Module-to-Arduino Headers (J5/J3) Module-to-Arduino Header (J4/J7) External HCI UART interface (J2) CYBLE-013025-00 Module Figure 1: CYBLE-013025-EVAL Top View To use the CYBLE-013025-EVAL, 1) Con gure the evaluation board headers/switches to the desired settings 2) Connect the evaluation board to a PC via a USB cable 3) Open the WICED Smart SDK, develop your application, program and test The Arduino compatible headers (J3/J4/J5/J7) are optional connections, which provide additional I/O connections to the module, and allows for Arduino Compatible shields to be used during development.TM EZ BLE MODULE ARDUINO EVALUATION BOARD CYBLE 013025 EVAL Figure 2: CYBLE-013025-EVAL Bottom View SW1: Jumper con guration for UART connections as shown in the below table: SW1 Position Position 1/2/3/4 = ON Position 1/2/3/4 = OFF Do Not Use HCI mode Position 5 and 6 = ON (HCI and PUART compete) Reprogramming or testing PUART Application Mode General Application Mode Position 5 and 6 = OFF PUART connected to host PUART disconnected from host SW2: Reset Switch routed to the XRES connection on the module. SW3: User-de ned Switch routed to the P24 connection on the module. SW4: Recover Switch routed to the SDA connection on the module. J1: Used for power supply current measurement. J2: Connection for external interface for direct HCI UART communication. J3/J4/J5/J7: Arduino-compatible headers used with an Arduino-compatible shield. J8: Con gures the VDD voltage input to the module as shown in the below table: J8 Jumper Con guration VDD Voltage Level Short 1 & 2 3.6V Short 2 & 3 3.3V No Jumper 2.3V J9: Connects the P24 pad on the module to SW3. J10: Connects the P14/38 pad on the module to LED D6. The CYBLE-0130XX-00 WICED Modules are quali ed for the Bluetooth 4.1 speci cation and are certi ed for the 2.4 GHz unlicensed frequency range in USA (FCC), Canada (ISED), Europe (CE) and Japan (MIC). Visit www.cypress.com/support for technical support. 2017 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of their respective owners. 002-19296 Rev.*A