TM EZ BLE ARDUINO EVALUATION BOARD CYBLE 416045 EVAL The EZ-BLE Arduino evaluation board (CYBLE-416045-EVAL) enables you to evaluate and develop applications on the CYBLE-416045-02 EZ-BLE Creator module. CYBLE-416045-EVAL can be used as a standalone evaluation kit or can be combined with Arduino compatible shields. The CYBLE-416045-02 is a fully integrated, fully certi ed, 14.0 mm x 18.5 mm x 2.00 mm, programmable, Bluetooth Smart module designed to reduce your time-to-market. For more information, visit: TM www.cypress.com/bluetooth modules - EZ-BLE/EZ-BT Module home page www.cypress.com/EZ-Serial - EZ-Serial Firmware Platform TM www.cypress.com/Creator - PSoC Creator IDE USB Connector (J1) User De ned Switch (SW2) P9.5-LED3/Blue Jumper (J12) Reset Switch (SW1) PSoC5 LP SWD Header (J3) VDD Setting (J2) Module SWD Header (J9) P0.4-SW2 Jumper (J10) Module-to-Arduino Header (J5) Module-to-Arduino Header (J4) VDD Jumper (J8) Module-to-Arduino Header (J7) Module-to-Arduino Header (J6) P9.6-LED3/Green Jumper (J13) CYBLE-416045-02 Module P9.4-LED3/Red Jumper (J11) Figure 1: CYBLE-416045-EVAL Top View To use the CYBLE-416045-EVAL: 1) Con gure the evaluation board headers and switches to the desired settings 2) Connect the evaluation board to a PC via a USB cable 3) Open the Creator IDE and create a project using the CYBLE-416045-02 MPN and program and debug using PSoC Creator The Arduino compatible headers (J4, J5, J6, and J7) are optional connections, which provide additional I/O connections to the module and allow for other Arduino shields to be used during development.TM EZ BLE ARDUINO EVALUATION BOARD CYBLE 416045 EVAL Figure 2: CYBLE-416045-EVAL Bottom View SW1: Reset switch routed to the XRES connection on the module. SW2: User-de ned switch routed to the P0.4 connection on the module via J10. J1: Micro-USB connector. J2: Con gures the VDD voltage input to the module as shown in the below table: J2 Jumper Con guration VDD Voltage Level Short 3.3 V Open 1.8 V J3: PSoC5 LP SWD Program/Debug Interface. J4/J5/J6/J7: Arduino-compatible headers used with an Arduino compatible shield. J8: Module power supply current measurement header. J9: CYBLE-416045-02 SWD Program/Debug Interface. J10: Connects or disconnects P0.4 pad of CYBLE-416045-02 to SW2. J11/12/13: Connects the P9.4, P9.5, and P9.6 pads to LED3 Red, Blue, and Green respectively. The EZ-BLE CYBLE-416045-02 module is quali ed for the Bluetooth 5.0 speci cation and is certi ed for the 2.4 GHz unlicensed frequency range in USA (FCC), Canada (ISED), Europe (CE), and Japan (MIC). Visit www.cypress.com/support for technical support. 2018 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of their respective owners. 002-24484 Rev.**