CYBT-343026-EVAL Infineon

TM EZ BT MODULE ARDUINO EVALUATION BOARD CYBT 343026 EVAL The EZ-BT Module Arduino Evaluation Board (CYBT-343026-EVAL) enables you to evaluate and develop applications on the EZ-BT WICED Module, CYBT-343026-01. CYBT-343026-EVAL can be used as a standalone evaluation kit or can be combined with Arduino compatible shields. The CYBT-343026-01 WICED Module is a fully integrated, fully certi ed, 12.0 mm x 15.5 mm x 1.95 mm, programmable, Bluetooth Smart Ready module designed to reduce your time-to-market. For more information, visit: www.cypress.com/EZ-BLEModule - EZ-BLE Module home pages www.cypress.com/EZ-Serial - EZ-Serial Bluetooth Firmware Platform page www.cypress.com/WICED - WICED Platform page Supply Option (J8) USB Connector Reset Switch (SW1) Recover Switch (SW2) HCI UART Switch (SW4) Operation Mode Switch (SW5) User-de ned Switch (SW3) P0/P34-SW3 Jumper (J9) Module-to-Arduino Headers (J7/J4) Module-to-Arduino Headers (J3/J6) VDD Jumper (J2) External HCI UART interface (J1) CYBT-343026-01 Module P2/P28/P37-D1 Jumper (J10) Figure 1: CYBT-343026-EVAL Top View To use the CYBT-343026-EVAL: 1) Con gure the evaluation board headers/switches to the desired settings 2) Connect the evaluation board to a PC via a USB cable 3) Refer to KBA221025 for platform les, Make le target generation, and HCI UART switch position setting for programming 4) Open the WICED Studio IDE, develop your application, program and test The Arduino compatible headers (J3/J4/J6/J7) are optional connections, which provide additional I/O connections to the module and allow for other Arduino shields to be used during development.TM EZ BT MODULE ARDUINO EVALUATION BOARD CYBT 343026 EVAL Figure 2: CYBT-343026-EVAL Bottom View SW1: Reset Switch routed to the XRES connection on the module. SW2: Recover Switch routed to the SPI2 MOSI connection on the module. SW3: User-de ned Switch routed to the P0/P34 connection on the module via J9. SW4: Switch connecting HCI UART connections on the module to host via USB. SW5: Switch connecting PUART connections on the module to host via USB. J1: Connection for external interface for direct HCI UART communication. J2: Used for power supply current measurement. J3/J4/J6/J7: Arduino-compatible headers used with an Arduino compatible shield. J8: Con gures the VDD voltage input to the module as shown in the below table: J8 Jumper Con guration VDD Voltage Level Short 1 & 2 3.6V Short 2 & 3 3.3V No Jumper 2.3V J9: Connects the P0/P34 pad on the module to SW3. J10: Connects the P2/P28/P37 pad on the module to LED D1. The EZ-BT WICED Module is quali ed for the Bluetooth 5 speci cation and is certi ed for the 2.4 GHz unlicensed frequency range in USA (FCC), Canada (ISED), Europe (CE) and Japan (MIC). Visit www.cypress.com/support for technical support. 2017 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of their respective owners. 002-20852 Rev.*A