S25FL116K S25FL132K, S25FL164K 16 Mbit (2 Mbyte), 32 Mbit (4 Mbyte), 64 Mbit (8 Mbyte) 3.0 V NVM Features Serial Peripheral Interface (SPI) with Multi-I/O Top / Bottom relative Block Protection Range, 4 kB to all of memory SPI Clock polarity and phase modes 0 and 3 8-Byte Unique ID for each device Command subset and footprint compatible with S25FL-K Non-volatile Status Register bits control protection modes Read Software command protection Normal Read (Serial): Hardware input signal protection 50 MHz clock rate ( 40 C to +85 C/105 C) Lock-Down until power cycle protection 45 MHz clock rate ( 40 C to +125 C) OTP protection of security registers Fast Read (Serial): 90 nm Floating Gate Technology 108 MHz clock rate (40 C to +85 C/105 C) Single Supply Voltage 97 MHz clock rate ( 40 C to +125 C) Dual Read: 2.7 V to 3.6 V (Industrial, Industrial Plus, and Extended temperature range) 108 MHz clock rate (40 C to +85 C/105 C) 2.6 V to 3.6 V (Extended temperature range) 97 MHz clock rate ( 40 C to +125 C) Quad Read: Temperature Ranges 108 MHz clock rate (40 C to +85 C/105 C) Industrial ( 40 C to +85 C) 97 MHz clock rate for S25FL164K (40 C to +125 C) Industrial Plus ( 40 C to +105 C) 54 MB/s maximum continuous data transfer rate Extended ( 40 C to +125 C) ( 40 C to +85 C/105 C) Package Options Efficient Execute-In-Place (XIP) S25FL116K Continuous and wrapped read modes 8-lead SOIC (150 mil) SOA008 Serial Flash Discoverable Parameters (SFDP) 8-lead SOIC (208 mil) SOC008 Program 8-contact WSON 5 mm x 6 mm WND008 Serial-input Page Program (up to 256 bytes) 24-ball BGA 6 mm 8 mm FAB024 and FAC024 Program Suspend and Resume KGD / KGW Erase S25FL132K Uniform sector erase (4 kB) 8-lead SOIC (150 mil) SOA008 8-lead SOIC (208 mil) SOC008 Uniform block erase (64 kB) 8-contact USON 4 mm 4 mm UNF008 Chip erase 8-contact WSON 5 mm 6 mm WND008 Erase Suspend and Resume 24-ball BGA 6 mm 8 mm FAB024 and FAC024 Cycling Endurance KGD / KGW 100K Program-Erase cycles on any sector, minimum S25FL164K Data Retention 8-lead SOIC (208 mil) SOC008 20-year data retention, typical 16-lead SOIC (300 mil) SO3016 Security 8-contact WSON 5 mm 6 mm WND008 Three 256-byte Security Registers with OTP protection 24-ball BGA 6 mm 8 mm FAB024 and FAC024 Low supply voltage protection of the entire memory KGD / KGW Pointer-based security protection feature (S25FL132K and S25FL164K) Cypress Semiconductor Corporation 198 Champion Court San Jose, CA 95134-1709 408-943-2600 Document Number: 002-00497 Rev. *D Revised December 18, 2015S25FL116K S25FL132K, S25FL164K Performance Summary Maximum Read Rates (V = 2.7 V to 3.6 V, 85 C/105 C) CC Command Clock Rate (MHz) Mbytes/s Read 50 6.25 Fast Read 108 13.5 Dual Read 108 27 Quad Read 108 54 Typical Program and Erase Rates (V = 2.7 V to 3.6 V, 85 C/105 C) CC Operation kbytes/s Page Programming (256-byte page buffer) 365 4-kbyte Sector Erase 81 64-kbyte Sector Erase 131 Typical Current Consumption (V = 2.7 V to 3.6 V, 85 C/105 C) CC Operation Current (mA) Serial Read 50 MHz 7 Serial Read 108 MHz 12 Dual Read 108 MHz 14 Quad Read 108 MHz 16 Program 20 Erase 20 Standby 0.015 Deep-Power Down 0.002 Document Number: 002-00497 Rev. *D Page 2 of 89