IS62WV25616ALL IS62WV25616BLL 256K x 16 LOW VOLTAGE, AUGUST 2014 ULTRA LOW POWER CMOS STATIC SRAM FEATURES DESCRIPTION The ISSI IS62WV25616ALL/IS62WV25616BLL are high- High-speed access time: 55ns, 70ns speed, low power, 4M bit SRAMs organized as 256K words CMOS low power operation by 16 bits. It is fabricated using ISSI s high-performance 36 mW (typical) operating CMOS technology. This highly reliable process coupled with innovative circuit design techniques, yields high-performance 9 W (typical) CMOS standby and low power consumption devices. TTL compatible interface levels When CS1 is HIGH (deselected) or when CS1 is LOW and Single power supply both LB and UB are HIGH, the device assumes a standby 1.65V--2.2V Vdd (IS62WV25616ALL) mode at which the power dissipation can be reduced down 2.5V--3.6V Vdd (IS62WV25616BLL) with CMOS input levels. Fully static operation: no clock or refresh Easy memory expansion is provided by using Chip Enable required and Output Enable inputs. The active LOW Write Enable (WE) controls both writing and reading of the memory. A data byte Three state outputs allows Upper Byte (UB) and Lower Byte (LB) access. Data control for upper and lower bytes The IS62WV25616ALL/IS62WV25616BLL are packaged Industr ial temperature available in the JEDEC standard 44-Pin TSOP (TYPE II) and 48-pin Lead-free available mini BGA (6mmx8mm). FUNCTIONAL BLOCK DIAGRAM 256K x 16 A0-A17 DECODER MEMORY ARRAY VDD GND I/O0-I/O7 I/O Lower Byte COLUMN I/O DATA CIRCUIT I/O8-I/O15 Upper Byte CS1 OE CONTROL CIRCUIT WE UB LB Copyright 2014 Integrated Silicon Solution, Inc. All rights reserved. ISSI reserves the right to make changes to this specification and its products at any time without notice. ISSI assumes no liability arising out of the application or use of any information, products or services described herein. Customers are advised to obtain the lat- est version of this device specification before relying on any published information and before placing orders for products. Integrated Silicon Solution, Inc. does not recommend the use of any of its products in life support applications where the failure or malfunction of the product can reason- ably be expected to cause failure of the life support system or to significantly affect its safety or effectiveness. Products are not authorized for use in such applications unless Integrated Silicon Solution, Inc. receives written assurance to its satisfaction, that: a.) the risk of injury or damage has been minimized b.) the user assume all such risks and c.) potential liability of Integrated Silicon Solution, Inc is adequately protected under the circumstances Integrated Silicon Solution, Inc. www.issi.com 1-800-379-4774 1 Rev. F 08/25/2014IS62WV25616ALL, IS62WV25616BLL PIN CONFIGURATIONS 44-Pin mini TSOP (Type II) 48- ball mini BGA (6mm x 8mm) (Package Code T) (Package Code B) A4 1 44 A5 1 2 3 4 5 6 A3 2 43 A6 A2 3 42 A7 41 A1 4 OE A0 5 40 UB CS1 6 39 LB I/O0 7 38 I/O15 I/O1 8 37 I/O14 A LB OE A0 A1 A2 NC I/O2 9 36 I/O13 I/O3 10 35 I/O12 I/O UB A3 A4 CSI I/O B 8 0 VDD 11 34 GND GND 12 33 VDD I/O I/O A5 A6 I/O I/O C 9 10 1 2 I/O4 13 32 I/O11 I/O5 14 31 I/O10 GND I/O A17 A7 I/O VDD 11 3 D I/O6 15 30 I/O9 VDD I/O NC A16 I/O GND I/O7 16 29 I/O8 E 12 4 WE 17 28 NC I/O I/O A14 A15 I/O I/O F 14 13 5 6 A16 18 27 A8 A15 19 26 A9 I/O NC A12 A13 WE I/O 15 7 G A14 20 25 A10 21 24 A13 A11 NC A8 A9 A10 A11 NC H A12 22 23 A17 44-Pin mini TSOP (Type II) 2 Chip Enable Option (Package Code T2) PIN DESCRIPTIONS A4 1 44 A5 A3 2 43 A6 A0-A17 Address Inputs A2 3 42 A7 I/O0-I/O15 Data Inputs/Outputs A1 4 41 OE A0 5 40 UB CS1, CS2 Chip Enable Input CS1 6 39 LB OE Output Enable Input I/O0 7 38 I/O15 I/O1 8 37 I/O14 WE Write Enable Input I/O2 9 36 I/O13 LB Lower-byte Control (I/O0-I/O7) 35 I/O3 10 I/O12 VDD 11 34 GND UB Upper-byte Control (I/O8-I/O15) GND 12 33 VDD NC No Connection I/O4 13 32 I/O11 I/O5 14 31 I/O10 Vdd Power I/O6 15 30 I/O9 GND Ground I/O7 16 29 I/O8 WE 17 28 CS2 A16 18 27 A8 A15 19 26 A9 A14 20 25 A10 A13 21 24 A11 A12 22 23 A17 2 Integrated Silicon Solution, Inc. www.issi.com 1-800-379-4774 Rev. F 08/25/2014