GPY21x Ethernet Network Connection 2.5Gigabit Ethernet PHY for Routers, Switches, and Gateway PRODUCTS GPY211 Single-port 2.5GbE PHY GPY212 Single-port 2.5GbE PHY that includes MACsec GPY215 Single-port 2.5GbE PHY for industrial applications that includes MACsec and SynE GPY115 Single-port 1GbE PHY for industrial applications that includes MACsec and SynE FEATURES Full and half-duplex modes for 10BASE-T(e), 100BASE-T, 1000BASE-T, and 2.5GBASE-T Single power supply at 3.3V that uses the integrated DC/DC switching regulator Single-row VQFN-56 package (7 x 7mm) Low power consumption of typically 1.3W at 2.5GBASE-T Precise time stamping according to the IEEE 1588 Version 2 and Synchronous Ethernet (SyncE) 2.5Gigabit Ethernet PHY for Routers, Smart LED brightness control integrated for the Switches and Gateways link status display Smart AZ for legacy MAC to support Faster Ethernet connectivity enables users to make the most of IEEE 802.az power saving in idle mode increased speeds available through the enhanced broadband access Rate adaptation for fix MAC rate with different networks. 2.5Gigabit Ethernet (GbE) increases the bandwidth without TP speed. changing cables and it is more cost-effective and consumes less Remote firmware upgradable through external power than 5GbE or 10GbE. optional flash. Programmable thermal sensor to monitor the The Ethernet network connection of the GPY21x device is a 2.5GbE device temperature for the system warning and PHY that is suited for routers, switches, and home gateways. It the down speed provides interoperability for NBaseT and the new IEEE 802.3bz Industrial temperature range is from -40C to standard. It is also optimized to work with 2.5GbE PHY for PCs. 85C (GPY215 and GPY115) Jumbo frames of up to 10KB The device temperature is monitored by an internal thermal sensor Cable diagnostics that provides thermal information for system warnings or initiates Auto down speed for Cat3 (four wires) speed reduction to prevent system overheating. It supports a timing or bad cable synchronization according to the IEEE 1588v2 and SyncE standard Auto MDI/MDI-X and auto polarity correction required for Industrial, transportation, and mobile networking. Wake-on-LAN The GPY212/GPY215/GPY115 device also supports MACsec MACsec,16 security channels and 32 association numbers (GPY212 only) point-to-point wire speed data security. The GPY21x is configurable through pin strapping, MDIO interface, or external flash. MAIN APPLICATIONS Broadband router: xPON, wireless, 4G/5G, G.Fast, G.hn, cable, xDSL Standards: Home gateway: wireless gateway, home server, IEEE 802.3az: Energy-Efficient Ethernet IEEE 802.3: Relevant clauses home storage (NAS) IEEE 1588 Version 2 and SyncE IEEE 802.3bz and NBASE-T High port and low port count 2.5GbE switch IEEE 802.1AE MACSec Dual-band dual-concurrent 802.11ac/ax enterprise access point Ethernet, MoCA, and G.hn solutions provide wireline, multi-gigabit data distribution throughout the connected home Wired Connectivity GPY21x Ethernet Network Connection Router/Gateway Applicaon High Port and Low Port Count Switch Applicaon The rate adaptation function is to help MAC which cannot Small Footprint and RBOM support lower speed. The fix MAC rate between PHY and FEM FEM MaxLinear SGMII+ The GPY21x device is packaged in a small 7 x 7mm Ethernet Network 10/25/40 GbE MAC and TP interface run at different speed. High Port Connecon GPY21x Uplink Wi-Fi 5 or Wi-Fi 6 Wi-Fi 5 or Wi-Fi 6 single-row VQFN-56, ideal for 2 or 4-layer PCBs. chipset chipset and The low EMI line driver with integrated termination PCIe PCIe 5 ~ 16 Low Power Consumption Low Port 10/25/40 GbE simplifies the PCB design. The SGMII interface supports Uplink MaxLinear 2.5 GbE LAN SGMII+ Count 4x The GPY21x device has a low power Ethernet Switch consumption MaxLinear 10/100/1000/2500Mbps speeds. The device can be SGMII+ FE/GE Switch DOCSIS 3.1 Ethernet Network GSW140 of 1.3W in 2.5GBASE-T mode. The device supports xDSL Connecon GPY21x SOC operated from a single 3.3V power supply using the G.fast xPON energy-efficient Ethernet to reduce power consumption SGMII+ MaxLinear DRAM FLASH integrated DC/DC switching regulator. 2 .5 GbE Ethernet Network depending on traffic. Additionally, the power can be saved at Connecon GPY21x the system level by using the wake-on-LAN (WoL) functionality, DRAM FLASH the ultra-low power mode, and the no link states. MaxLinear FEM FEM SGMII+ GPY21x 10/25/40GbE Ethernet Network High Port Uplink Wi-Fi 5 or Wi-Fi 6 Wi-Fi 5 or Wi-Fi 6 Connecon Chipset Chipset and PCIe PCIe 5 ~ 16 Low Port 10/25/40GbE Uplink MaxLinear 2.5GbE LAN SGMII+ Count 4x MaxLinear GSW140 SGMII+ FE/GE GPY21x Switch DOCSIS 3.1 Ethernet Switch Ethernet Network xDSL SOC Connecon G.fast xPON MaxLinear SGMII+ DRAM FLASH 2.5GbE GPY21x Ethernet Network Connecon DRAM FLASH High Port and Low Port Count Switch Applicaon Router and Gateway Applicaon FEM FEM MaxLinear SGMII+ Product Information 10/25/40 GbE Ethernet Network High Port Connecon GPY21x Uplink Wi-Fi 5 or Wi-Fi 6 Wi-Fi 5 or Wi-Fi 6 chipset chipset and Product Description Ordering Code Package PCIe PCIe 5 ~ 16 Low Port 10/25/40 GbE GPY211 Ethernet Network Connection Single-port 2.5GbE PHY GPY211B1VC VQFN-56 Uplink MaxLinear 2.5 GbE LAN Count SGMII+ 4x Ethernet Switch MaxLinear SGMII+ FE/GE GPY212 Ethernet Network Connection Single-port 2.5GbE PHY including MACsec GPY212B1VC VQFN-56 Switch DOCSIS 3.1 Ethernet Network GSW140 xDSL Connecon GPY21x SOC G.fast GPY215 Ethernet Network Connection Single-port 2.5GbE PHY for industrial applications including MACsec and SynE GPY215B1VI VQFN-56 SGMII+ xPON MaxLinear DRAM FLASH .5 GbE GPY115 Ethernet NetworkEthe Cornennet Necttiworkon Single-port 1GbE PHY for industrial applications including MACsec and SynE GPY115B1VI VQFN-56 Connecon GPY21x DRAM FLASH Corporate Headquarters: 5966 La Place Court Suite 100 Carlsbad, CA 92008 Tel.:+1 (760) 692-0711 Fax: +1 (760) 444-8598 www.maxlinear.com The content and information contained in this document is furnished for informational or general marketing purposes only, is subject to change without notice, and should not be construed as a commitment by MaxLinear, Inc. MaxLinear, Inc. assumes no responsibility or liability for any errors, inaccuracies, or incompleteness that may appear in the informational content contained in this guide. Reproduction, in part or whole, without the prior written consent of MaxLinear, Inc. is prohibited. MaxLinear, the MaxLinear logo, and any MaxLinear trademarks MxL, Full-Spectrum Capture, FSC, G.now, AirPHY, Puma, and AnyWAN are all trademarks of MaxLinear, Inc. or one of MaxLinears subsidiaries in the U.S.A. and other countries. Other company trademarks and product names appearing herein are the property of their respective owners. 2020 MaxLinear, Inc. All rights reserved. 001FLR00 2/2