SY100EL33LZG Microchip

SY100EL33L 3.3V ECL 4 Divider Features General Description 3.3V Power Supply The SY100EL33L is an integrated 4 divider. The differential clock inputs and the V allow a differential, 640ps Propagation Delay (typical) BB single-ended or AC-coupled interface to the device. If 4.2 GHz Toggle Frequency (typical) used, the V output should be bypassed to ground BB High Bandwidth Output Transitions with a 0.01F capacitor. Also note that the V is BB Internal 75 k Input Pull-Down Resistors designed to be used as an input bias on the EL33L Available in 8-Pin SOIC Package only the V output has limited current sink and source BB capability. The Reset pin is asynchronous and is asserted on the rising edge. Upon power-up, the internal flip-flops will attain a random state the Reset input allows for the synchronization of multiple EL33Ls in a system. Package Type SY100EL33L 8-Pin SOIC (Z8-1) 2018 Microchip Technology Inc. DS20006076A-page 1SY100EL33L 1.0 ELECTRICAL CHARACTERISTICS Absolute Maximum Ratings PECL Power Supply Voltage (VCC) (Note 1)+8V NECL Power Supply Voltage (VEE) (Note 2)-8V PECL Mode Input Voltage (VIN) (Note 3) +6V NECL Mode Input Voltage (VIN) (Note 4) -6V Continuous Output Currrent (IOUT)50mA Surge Output Currrent (IOUT).......100mA Notice: Stresses above those listed under Absolute Maximum ratings may cause permanent damage to the device. Exposure to maximum rating conditions for extended periods may affect device reliability. EE = 0V Note 1: V CC = 0V 2: V EE = 0V, VIN VCC 3: V 4: VCC = 0V, VIN VEE TABLE 1-1: DC ELECTRICAL CHARACTERISTICS Electrical Characteristics PECL: VCC = 3.0V to 3.8V VEE = 0V TA = -40C to 85C, unless otherwise stated (Note 1) Parameter Symbol Min. Typ. Max. Units Test Condition Power Supply Voltage VCC 3.0 3.3 3.8 V 27 33 TA = -40C to +25C Power Supply Current IEE mA 31 37 TA = +85C VCC 1.085 VCC 1.005 VCC 0.88 TA = -40C Output High Voltage (Note 2) VOH V VCC 1.025 VCC 0.955 VCC 0.88 TA = 0C to 85C VCC 1.830 VCC 1.695 VCC 1.555 TA = -40C Output Low Voltage (Note 2) VOL V VCC 1.810 VCC 1.705 VCC 1.620 TA = 0C to 85C Input High Voltage VIH VCC 1.165 VCC 0.880 V (Single Ended) Input Low Voltage VIL VCC 1.810 VCC 1.475 V (Single Ended) Output Reference Voltage VBB VCC 1.38 VCC 1.26 V Input High Current IIH 150 A Input Low Current IIL 0.5 A VIN = VIL (Min) Note 1: Devices are designed to meet the DC specifications shown in the above table after thermal equilibration has been established. The circuit is in a test socket or mounted on a printed circuit board and transverse airflow greater than 500lfpm is maintained. 2: Outputs are terminated through a 50 resistor to VCC 2.0V. 2018 Microchip Technology Inc. DS20006076A-page 2