Preliminary SF2261E 880 MHz Low-loss SAW Filter, 60 MHz Bandwidth Pb Surface Mount 3.0 x 3.0 x 1.3 mm Package 880 MHz Complies with Directive 2002/95/EC (RoHS) SAW Filter Absolute Maximum Ratings Rating Value Units Input Power Level 15 dBm DC Voltage on any Non-ground Terminal 3 V Operating Temperature Range -40 to +85 C Storage Temperature Range -40 to +95 C Solder Reflow Temperature, 10 seconds, 5 cycles maximum 260 C SM3030-6 Electrical Characteristics Characteristic Sym Notes Min Typ Max Units Center Frequency F 880 MHz C 2 dB Passband, 850 to 910 MHz 60 MHz Minimum Passband Insertion Loss IL 1.6 2.5 dB MIN Amplitude Variation 865 to 895 MHz 0.3 1.0 dB P-P Return Loss, 850 to 910 MHz 8.0 9.0 dB Attenuation, Referenced to 0 dB DC to 800 MHz 20 22 1003 to 1028 MHz 25 29 dB 1730 to 1780 MHz 25 32 Source Impedance Z 50 S Load Impedance Z 50 L Case Style SM3030-6 3.0 x 3.0 mm Nominal Footprint Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator A14, YWWS Standard Reel Quantity Reel Size 7 Inch 500 Pieces/Reel Reel Size 13 Inch 3000 Pieces/Reel CAUTION: Electrostatic Sensitive Device. Observe precautions for handling. Notes: 1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance matching to 50 and measured with 50 network analyzer. 2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc. 3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external impedance matching design. See Application Note No. 42 for details. 4.LRI or after the part number indicateslow rate initial productio andEN or indicatesengineering prototypes 5. The design, manufacturing process, and specifications of this filter are subject to change. 6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port 2, so that the filter must always be installed in one direction per the circuit design. 7. US and international patents may apply. 8. Murata, stylized Murata logo, and Murata N.A., Inc. are registered trademarks of Murata Manufacturing Co., Ltd. Copyright Murata Manufacturing Co., Ltd. All rights reserved. SF2261E (R) 6/2/16 Page 1 of 5 www.murata.comFilter Response Plots Copyright Murata Manufacturing Co., Ltd. All rights reserved. www.murata.com SF2261E (R) 6/2/16 Page 2 of 5